Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Mark 1 spray gun

Posts

Mark 1 spray gun

#1

Mark 1 spray gun

Jim Shockey

I just picked up a mark 1 spray gun and was wondering if anybody could tell me a little about it. Can I shoot poly with it or not. Thank you, Jim

Re: Mark 1 spray gun

#2

Sorry

Mark Mandell - Gone Round In Jersey

to answer a question with questions, but

1. Top cup, siphon feed bottom cup, pressure feed bottom cup?

2. Size tips?

3. Oil based or water based?

Re: Mark 1 spray gun

#3

Re: Sorry

del schisler

here is what i found on the spray gun. I don't thank you will be able to spray poly with those nozzel size's. I spray lacquer all the time with a 2 mm size. Don't know about poly size nozzel. some one will chim in with more i am sure . Here is the speck's i found.

Nozzles Included (qty.) 2

Required CFM 4.5

Operating PSI 30 - 40

Air Inlet Size (in. NPT) 1/4

Nozzle Size (mm) 1.0, 1.5

Paint Cup Size (oz.) 4 1/4, 20 1/4

Paint Cup Material Plastic

Case Included Yes

Manufacturer Warranty 12 months parts / 12 months labor

Ship Weight 7.0 lbs

Item# 156409

Re: Mark 1 spray gun

#4

Re: Size

Mark Mandell - Gone Round In Jersey

Dell,

I've sprayed Mixwax oil-based gloss poly with a 1.5mm cap. You have to thin the product a bit (I used 25% b/v naptha) and 40 psi supplied to the gun with a wide fan. Material flowed out quite nicely.

I shoot WB poly often through a 1.4mm cap with no problem.

Re: Mark 1 spray gun

#5

Thanks Mark for info     Re: Size

del schisler

I jsut havent need to spray other than lacquer. I know some one would know. thanks del

Re: Mark 1 spray gun

#6

Re: Thanks Mark for info     Re: Size

Jim Shockey

Thanks everybody for the help on this gun. I can't even find out who makes the darn thing so I can't even get some different tips. thanks again for your help. Jim

Re: Mark 1 spray gun

#7

Re: Size -PS

Mark Mandell - Gone Round In Jersey

Remember that when you're spraying any waterborne, especially through a smaller (1.4/1.5 tip) that you MUST strain the finish just before using it. A standard painter's paper/mesh filter cone will do (rinse and reuse) to remove any lumps of thickened product that would clog your tip. While some finishes will do beautifully at true HVLP in the lower pressure ranges, heavier bodied fluids may need more air to properly atomize in an even cone. I always start a new batch by spraying a sheet of white copy paper with a single pass. I then hold the sheet up to back light and check the density of the finish across the surface.

Good Luck :)