Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

What sort of knob??

Posts

What sort of knob??

#1

JL

What sort of knob??

JL

It's for Bev, the choir director. About 30" high, 40" wide and 24" deep.

Vaguely mission style. Mortise and tenons, loose tenon joinery. Oak.



I was planning on an oil/varnish mix.

Re: What sort of knob??

#2

Re: What sort of knob??

Barry Irby

I have a black hammered or wrought iron drop pull that would work. Or you could use a black wrought knob.

Good looking table. Nice work.

Re: What sort of knob??

#3

Re: What sort of knob??

Bill Houghton, Sebastopol, CA

Concur on the knob. Lee Valley has a nice, reasonably priced selection.

Re: What sort of knob??

#4

(Message Deleted by Poster)

Galen Vetterick

Re: What sort of knob??

#5

Moses Yoder

Re: What sort of knob?? *LINK*

Moses Yoder

Click on the link below and take #4 from the left in the top row. You could either ebonize it for contrast or stain it to match. Hey, you asked for my advice, now you got it.


Wood Pyramid Knob

Re: What sort of knob??

#6

turned oak knob

Bill Tindall

I like the way you used the grain of the oak. Nice.

Re: What sort of knob??

#7

My weakness . . .

steve mackay

is brass with ANY wood. OR gold plate, wich ever.

Re: What sort of knob??

#8

Re: What sort of knob??

Barry Irby

Galen, I can't believe you had the balls to post that picture. :D

That's the drop pull of which I have the black hammered version.

Re: What sort of knob??

#9

Kneale Brownson

I'm with Bill

Kneale Brownson

Turned or--one I like--same wood as the subject doubled up and cut in an oval shape on an angle so the outer face is bigger than the inner. I do this with a scroll saw.

Re: What sort of knob??

#10

Re: What sort of knob??

Mark Salomon

First, your vaguely mission desk deserves a bit more ornamentation that a turned knob IMHO. I think a Stickley pull would be really nice. You can spring for a hand hammered copper pull from Arts and Crafts Hardware (roughly $40) or a nice facsimile from Lee Valley for much less. While I'm a big fan of oil and varnish I don't like to use it as a final top coat for something that will get alot of wear. I suggest that you use the oil and varnish but then put a couple of coats of something like General Finishes wipe on urethane on the top to protect it a little better.

Re: What sort of knob??

#11

Dale Lenz

Re: What sort of knob?? *LINK*

Dale Lenz

How about the fifth pull from bottom in the link?


Round W.iron pulls, hammered.