Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Round over dovetail

Posts

Round over dovetail

#1

Round over dovetail

Greg Muller

I making a keepsake box for my daughter. Is it possible to round over the dove tail joint. I want to round over the edges on the lid section which would mean also rounding over the joint at the ends. Is this advisable or will it mess up the joint?

Re: Round over dovetail

#2

Re: Round over dovetail

Jon Weisenbach

My thought would be to make a sample joint and try different sized radius'd round-over's. That way you can see the results first hand and decide if it's the effect you want! just say'n :D :D

Re: Round over dovetail

#3

I agree - test it

Bill Houghton, Sebastopol, CA

If you're doing router-made dovetails, rounding them over may expose the rounded-off "behind the scenes" part of the joint - which may or may not look good (trying to think about the effect, and can't visualize it).

If you're doing hand-cut dovetails, your lines will be more consistent, but rounding over will place even more emphasis than usual on the need for perfection in the joint.

Re: Round over dovetail

#4

Re: Round over dovetail

JMOHNIKE

I have done this on several projects, from small boxes to larger tool boxes with no problems.

The key is a well made/cut dove tail.

Joe

Re: Round over dovetail

#5

Re: Round over dovetail

del schisler

sure round them over you are just knocking off the sharp edge. You are not taking that much off. If you are thing of tare out just take a little off at a time. May depend's on the wood. Like oak it may tare out some??