Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

OT Chevy silverado side mirror

Posts

OT Chevy silverado side mirror

#1

OT Chevy silverado side mirror

Andy Lincoln,in Dearborn MI

Hi All,

Hoping the collective wisdom can help.recently my driver's side mirror has come loose from it's pivot point.The mirror folds in(if needed) when not in use.Mine has become loose.I can see a large star washer and a spring that keeps the tension on the pivot.The housing nor the mirror are broken and I'd like to keep it that way.I cannot see any way to disaasemble the unit to access this spring/washer to re-tighten the unit.Any ideas?

TIA,

Andy

Re: OT Chevy silverado side mirror

#2

Re: OT Chevy silverado side mirror

Joseph Mulherin

Andy, searching around I found out that there is a triangular panel on the inside of the door which must be pried off to get to the innards of the mirror adjustment screws.

Re: OT Chevy silverado side mirror

#3

Re: OT Chevy silverado side mirror

Andy Lincoln,in Dearborn MI

Thanks Joseph.I managed to get the entire housing off the truck with little problem.I then found the PDF linked below and page 11 gave me the info I needed to get to the stem I needed to repair.Who knew you could just pry the mirror off of its mounts??Anyhow after getting it disassembled I was lucky enough to use a couple clamps to compress the spring and start washer back into place and atleast for now they are holding together in the right spot.Tomorrow will tell the story as I have an 85 mile commute to work in the morning.

Thanks for the help.

Re: OT Chevy silverado side mirror

#4

van mirrors

Jerry Gibbs

When I asked at the junk yard for a mirror for my extended econoline van, they laughed. Seems van mirrors are hard to keep in stock.

Re: OT Chevy silverado side mirror

#5

I did

Dustmaker Mike

I am planning on making my turn signal light into an LED strip and putting one on the back side of the mirror as well. I have been studying this for a little while now and have all the stuff I need except a good place to get the LED strips. All be it mine is a F150.