Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Cabinet top edge profiles . . .

Posts

Cabinet top edge profiles . . .

#1

Cabinet top edge profiles . . .

steve mackay

I'm getting to the point of starting the top for my tool box/cabinet. The top doesn't open as the gage box will reside there. Going to be solid with about a half inch over hang on the sides and front for some cove molding under the edge. Trying to decide about the shape/profile of the top edge. Wanted to "shop around" for some examples. I haven't stumbled on a term/question Google might match to what I'm after. Any suggestions of what I might ask the Devil Machine ?

Re: Cabinet top edge profiles . . .

#2

Re: Cabinet top edge profiles . . .

del schisler

how about just a round over?? Don't set the bit higher than the round over. Unless you want the little grove . I use this on all my jewelry and trinket box's. Some with 1/4" and some 1/2" depend's on wide and how deep the top and botton are.

Re: Cabinet top edge profiles . . .

#3

Moses Yoder

Re: Cabinet top edge profiles . . .

Moses Yoder

Google Ballew Saw & Tool, they will be the top hit. Click on the link for router bits, then click on the page for edging & grooving bits. There selection will give you quite a number of ideas, although a simple roundover may be your final answer.

Re: Cabinet top edge profiles . . .

#4

Thank Ye both . . .

steve mackay

As I don't have a router and this IS a first attempt at anything "cabinet", it might be prudent to keep this simple. Thank you both for applying the brakes and slowing the train down !

Re: Cabinet top edge profiles . . .

#5

Moses Yoder

Re: If you get a router 

Moses Yoder

Take a good look at the Bosch line.

Re: Cabinet top edge profiles . . .

#6

Couple ideas maybe...

John in NM

Not sure if this is the kind of thing for which you're looking, but it was easy enough to snap a couple pictures :D

First is from an old factory dresser. The top is rounded over with a small cove cut on the bottom edge and then a bolection molding added below. Total height is maybe 1 1/4"


Next is just an applied molding under a kitchen cabinet top. The top profile would be too wide for your overhang, but the applied molding would work with other stuff too. I forget what that molding is called, ogee and fillet or something (sorry about the over exposure :D )




You getting any smoke down there? I was down in Alamogordo yesterday, it was pretty hazy but no smoke smell like at home (maybe I was just used to it by then).

Re: Cabinet top edge profiles . . .

#7

OK ! . . .

steve mackay

Thank you. While I'm going to go with a beveled edge on top (about 3/8), now I can see the molding thing underneath. GI works better after seeing something once.

Smoke ? You know the deal down here. With the smoke from all the tire fires for cooking we wouldn't notice more 'till it hits the Grape Vine in the Lincoln. LOML was "playing" at the Inn of the Mountain Gods last week and said Riodouso was dry as a bone. They tend to keep their forrest "cleaned out" and tiddy though. Some precip would be nice though.

Re: Cabinet top edge profiles . . .

#8

Nooooooo . . .

steve mackay

I start trembling at the thought of going down the Router Road. Bad enough WC got me addicted to hand tools ! :b