Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Cut a drawer hole or piece?

Posts

Cut a drawer hole or piece?

#1

JL

Cut a drawer hole or piece?

JL

Scenario.

Table front with a 32" by 4 1/2" apron. Drawer in the middle that is going to be 18" or so wide. It is under the edge of the table so it really isn't going to show much. Drawer opening is going to be 18 x 3" or so.

Cut a hole or piece? I was planning on rabbeting the edges about 1/4" on each side.

Re: Cut a drawer hole or piece?

#2

Re: Cut a drawer hole or piece?

Barry Irby

I usually piece them. Actually rip that apron about a 1/4" wider than the opposite one and then mark it with diagonal chalk marks to help reassemble it. Then I rip the drawer piece out middle, Cut the drawer opening out of the rip, and then reassemble the apron with the opening centered in it. Doing it this way you can get pretty good grain match and the joints can be nearly invisible. Allow enough width for jointing the edges of the strips and centerpiece. If you allow a little extra length you can side slip the pieces to get better grain match. A quarter sawn or straight grained piece for the apron may work best. Also, with a little forethought you might be able to use the cutout as the drawer front.

Re: Cut a drawer hole or piece?

#3

Clint Searl

Per Barry's suggestion

Clint Searl


Re: Cut a drawer hole or piece?

#4

Moses Yoder

Re: Cut a drawer hole or piece?

Moses Yoder

We always cut a hole in the apron for end tables, with a CNC router. You could make a plywood jig to use with you router and a guide bushing, but you have to get a separate piece for the front. If you oversize the apron enough and cut it apart like Barry says you could use the cutout for the drawer front. I think cutting a hole in would be faster plus you don't have the glue joints to deal with, but it depends on your own objectives.

Re: Cut a drawer hole or piece?

#5

Yes.  Exactly the way I do it.

George@Colonel's Workshop-Havertown PA

Re: Cut a drawer hole or piece?

#6

Re: Cut a drawer hole or piece?

Steve Schoene

John Townsend made drawers in small tables by cutting a hole. He could then use the cut out piece for the drawer front because he added a cockbead attached to the rail to take up space left by the cutting. The cockbead also hides small tool marks on inside of the cut out where they are relatively hard to remove. On the drawer front, it can be brought to size and have any tool marks from the cutting process by a few swipes with a hand plane.

Re: Cut a drawer hole or piece?

#7

Re: Cut a drawer hole or piece?

Bill Tindall

This approach is what I have used. If the drawer shows obviously on the piece then having the gain all match is attractive.

Re: Cut a drawer hole or piece?

#8

Her is how charles neil does it  U tube vedio *LINK*

del schisler

here is how charles does it. He also has lot's of other video's


http://www.youtube.com/profile?user=InTheWorkshop#p/u/24/58YjE6u2dBk

Re: Cut a drawer hole or piece?

#9

Re: Cut a drawer hole or piece?

FredD

Excellent way to assemble a drawer and the Cock Bead has a lot going for it in appearance.

FredD