Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

spindle repair results

Posts

spindle repair results

#1

spindle repair results

DizD

I decided to repair this chair spindle rather than remake the whole piece. The top 4" or so was missing so I turned a replacement and cut a scarf joint and used slow set epoxy to put it together. Here it is with new wood installed.


And here after being wiped with stain and one coat of shellac. Final finish to be NC laquer. (Repair is second from right)


Re: spindle repair results

#2

Ellis Walentine

Nice job

Ellis Walentine

I don't think casual observers will ever notice, and if they do, they've got way too much time on their hands.

Good work.

Ellis Walentine, Host

Re: spindle repair results

#3

Dale Lenz

You're hired!

Dale Lenz

How did you cut the scarf joint?

Re: spindle repair results

#4

Slick ! (I still can't see it !)

steve mackay

Re: spindle repair results

#5

Well Done!

Mark Mandell - Gone Round In Jersey

Re: spindle repair results

#6

Either skill or blind luck

DizD

I'm still not sure which. I made a wood sided miter box a little wider than the spindle and cut what I thought was a suitable angle in the sides. I cut the broken end first after wedging the spindle to keep it from rolling. Then I held the new piece over the spindle end until it looked like it lined up, made a mark then cut it with the same miter saw kerf. I was amazed at the fit. Also waxed the inside of the box and used it to hold the pieces while the epoxy set.

Re: spindle repair results

#7

Re: spindle repair results

Dale Penkala

Looks exellent! Great job!

Dale

Mid-Michigan