Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Dovetailing question

Posts

Dovetailing question

#1

Dovetailing question

Bill Tindall

The situation: Typical cabinet wood-walnut, cherry, etc. the operation is wasting material between pins or tails and the length of material(length of base line between pins or tails) to be wasted is say 1" or 1 1/2". What size chisel do you use to chop/pare to the base line of the dovetail?

Do you use a wide chisel so as to whack out as much as possible per chisel setting, but with greater force because of the longer shaving? Or, to minimize whacking force on the chisel do you elect a smaller chisel- say 1/2" or 5/8- so that lighter taps can be used to drive the chisel.

I use, and have seen used, a smaller chisel so that light taps can be used to drive the chisel. But I would like to know how typical this choice is. What is your "go to" chisel width for waste chopping when the amount to be wasted is an inch or more?

(information needed for a chisel test)

Re: Dovetailing question

#2

Re: Dovetailing question

doug f, san clemente, ca

Bill - I've always tended to use a smaller chisel only because I feel I have more control, i.e., a 1/4" chisel for 1/2" dovetails.

Doug

Re: Dovetailing question

#3

JL

Re: Dovetailing question

JL

I'm far from expert. In the few instances where I've done hand cut dovetails, I usually got rid of most of the waste with a coping saw and then used a 1/2" or 3/8" chisel. I tried a larger chisel and I felt that I didn't have enough control.

Re: Dovetailing question

#4

Moses Yoder

Re: Dovetailing question

Moses Yoder

I usually cut the majority of the waste with a coping saw, then use the widest chisel I have that fits between the pins. Wider chisel = straighter line.

Re: Dovetailing question

#5

Re: Dovetailing question

Jesse Cloud

Ditto here. Hog out most of the waste with a bandsaw or coping saw, make a reference cut on the mark with a wide blade, then pare out with a slightly smaller blade.

Re: Dovetailing question

#6

Re: Dovetailing question

Ray - Middletown, In

1/2 and 5/8 for stock removal and 1 or 1 1/4 for clean up and smoothing.

Ray

Re: Dovetailing question

#7

Re: Dovetailing question

AZ in Colorado Springs

I make a bunch of cuts parallel to the cuts that define the pin or tail, down to within about 1/8" of the scribed line. Then with a 1/2" chisel it's easy to quickly knock out most of the waste.

To clean up the last bit of the waste to the scribed line, I use the widest chisel that will fit between the tails or pins (for the pin board that might imply different chisels on the two faces).

Re: Dovetailing question

#8

Re: Dovetailing question

Dave in Bryn Mawr PA

Japanese 1/2" fishtail chisel. Slight skew and thin shaft, especially for narrow pin cuts.