Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Drill Press Modification

Posts

Drill Press Modification

#1

Drill Press Modification

Jim Toews - Walla Walla, WA

Hey All,

I may have just reinvented the wheel, but I have a very stiff table height adjustment mechanism on my drill press, to the point of the crank handle having snapped off several times (replacements aren't that expensive, but it's a real pain when it happens). I have tried cleaning off the gunk they slather on for shipping, as well as lubricating the mechanism, all to no avail. This morning it occurred to me that a simple ratchet mechanism might be easier to use, so I drilled and tapped a 9/16 3/8 drive deep socket for a set screw and attached it to the spindle: voila! It is amazingly easy to raise and lower the table with my long ratchet attached. Like I said, this may be old hat to most people and I may be finally seeing the obvious, but it is a major improvement in function for a frequently used tool. On the other hand, I may have just set myself up for an even bigger parts failure in the future. Time will tell, but for now I'm quite pleased with it.

Cheers!

Jim

Re: Drill Press Modification

#2

Re: Drill Press Modification

Bill Houghton, Sebastopol, CA

Have you talked with tech support at the manufacturer's - assuming the manufacturer of your particular drill press has such a service? Perhaps there's some adjustment that will ease operation.

Re: Drill Press Modification

#3

Leo Cuellar

Re: Drill Press Modification

Leo Cuellar

Have you tried opening the locking lever farther? Maybe you have a very tight fitting clamp. It could be that you may have a burr somewhere in side that could cause this tightness. The gear may have slid to one side and be binding. The only way to check is to pull the table off & have a look see.

Re: Drill Press Modification

#4

Re: Drill Press Modification

Dale Penkala

I don't no what kinda drill press you have but another thought is if there is a nut that snugs up to the locking lever it maybe to close/tight to the clamp that tightens up to the column. If it is try loosening up that nut a 1/4 - 1/2 a turn and try that and see if that helps your problem. We have this very situation with some of our Okmoto surface grinders in the shop. These levers tend to be spring loaded but not always.

Good luck!

Dale

Mid-Michigan

Re: Drill Press Modification

#5

Re: Drill Press Modification

Jim Toews - Walla Walla, WA

It is a Delta 17" floor model. Whenever I try to move the table I do loosen the locking mechanism several turns (i.e. MUCH looser than should be necessary), and I have checked the crank mechanism for burrs, misallignments, etc.. Both times I called Delta to order a new crank handle the person I spoke with made no mention of any number to call for assistance, nor did they act as though this was a problem. The just took my information and several days later I had a new crank handle.

Please do NOT take this as a rant against Delta! Several times I have had problems with various machines, and they have always been most helpful, and when the machine in question was still under warranty they were the ones who pointed it out and refused my money. The drill press is well beyond the warranty period; I just happened to think of a solution after years of struggling with it and thought I'd share it in case others were having similar problems.

Oh, I should probably mention that the socket I used is a six-point socket. I chose six point over twelve point so as to have a thicker wall to give better support for the set screw.

Cheers!

Jim