Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Pole Buildings

Posts

Pole Buildings

#1

Pole Buildings

Kelly in Port Orchard

Hello All,

I am having a 34' X 48' pole building put up on my property to be used as a garage/work shop. It will have insulation installed plus a 4 inch concrete pad. I will do all the electrical, per code. My question: How hard is it to finish it off with sheetrock? I have never had any dealings with pole buildings before. They are very popular in this area but I want to fix it up where I can heat it in the winter. Looking at the blueprints the company provided; it looks like the support post are set 8 foot apart. I will have one roll-up door and one man door, plus windows. This bulding was a lot cheaper than convensional stick type plus I like having the metal siding and metal roof. Any suggestions or help would be greatly appreciated.

Thank you,

Re: Pole Buildings

#2

a contractor told me....

Bill Tindall

that if one wants to finish the inside it is better to go with conventional stud construction. Put down a row of block and caps on the pad and put plate and studs upon it.

Re: Pole Buildings

#3

Dale Lenz

Re: Pole Buildings

Dale Lenz

My house/property came with an all ready erected 20 X 42 pole barn/haybarn open 42' front, 6 X 6 post every 10'. Had pad poor inside the barn and built stud walls between between post. Screwed cottonwood 1 X 8 shipped lapped boards to studs. Worked great, although sheet rock or OSB panel would of been easier and quicker.

Re: Pole Buildings

#4

Ken Vaughan

Re: Pole Buildings

Ken Vaughan

You have choices -- you can treat it as if it was a "post and beam" construction because it is a variation of that -- and you should have no load bearing walls.

Depending on how far north (and how cold it gets) you may want to provide perimiter insulation and a double stud wall will provide you max insulation (breaks up the conducting of heat through the studs). Vapor barrier and air handling will be worth some careful thougth. How you handle dust collection and air return will be key.

Sounds like a good place -- used to build pole building when I was a kid -- saw them used for all kinds of space from homes to livestock shelters to shops.

Re: Pole Buildings

#5

Re: Pole Buildings

Gary Camp, Bend, Oregon

Port Orchard, Wa.? A few years ago (ok more than a few) a company I worked for had a metal pole barn built for a shop. The insulation that was installed was large batts wraped in plastic. We used self drilling / thread cutting screws and fastened 2X4's flat ways to the metal wall purlins 16" o.c. and nailed 1/2 plywood to it. It was felt we only need to protect the insulation up to 8 feet. We pole barn is all wood, 8X8 posts, 2X6 wall purlins (flat), nailed to the posts and notched 2X6's 16" o.c attached to the purlins with 4X8 sheets of LP board siding nailed over the whole works. I will sheet the second floor area using the existing "studs" good luck have fun in the shop.

glc