Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Almost ready...

Posts

Almost ready...

#1

Clint Searl

Almost ready...

Clint Searl

...for fast, neat, accurate work at my shop away from my shop. 31 x 78, screwed down replaceable ply top, and a Jorgensen vise from Woodworkers Supply. All that's left to do is to hang a shelf inside the 2x4's and cover the vise faces.

Clint


Re: Almost ready...

#2

That's a lot of cross grain construction..

Dick Coers

you have there Clint. Don't you think those 2x6s are going to fight the apron and plywood? I think you are going to have trouble with the top staying flat. Might surprise me, but something is going to give.

Re: Almost ready...

#3

Clint Searl

No problema

Clint Searl

Each 2x6 is attached to the front and back aprons with a single center screw, and the ply is attached to the 2x6's with three screws each to the front and back. If anything, the 2x6's will shrink in the NM climate, but the attachment points won't move. It's the same construction as my 18 year old bench in PA thats seen a lot more seasonal movement than this is likely to experience, without any problem.

Clint

Re: Almost ready...

#4

Clint Searl

P.S.

Clint Searl

Sometimes I stutter when I write.

I thought the internet went away when I sent the first reply.

Clint

Re: Almost ready...

#5

Moses Yoder

Re: Sprung joints

Moses Yoder

I bet you stayed up late at night in secret putting a little spring into all those 2x6 joints for the top.

The first bench I built was very similar to yours. It was nice and solid, but never did have good vices on it that worked well.

Re: Almost ready...

#6

Re: Sprung joints

FredD

It has always been my understanding that there were no "good vices" :D :D

FredD

Re: Almost ready...

#7

Actually

Mark Mandell - Gone Round In Jersey

They're All Good! That's the problem. :D