Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

raised bed gardening

Posts

raised bed gardening

#1

raised bed gardening

John Foster

Hello all; My wife and I are planning to give raised bed gardening a try this year. I have built 12" deep beds out of nominal 2"(therefore really 1.5") untreated lumber, and made them 4' by 6'. The corners are held together with 2.5" X 2.5" X 1/8" angle iron and 3/8" carriage bolts, so they should be good and strong. My question is, do you think I will see bowing on the 6' sides? Should I tie the sides together with metal rods? I have enough 3/8" rod on hand, it would just be the labour of threading one end and welding a head on the other. Thanks, John

Re: raised bed gardening

#2

Re: raised bed gardening

Jesse Cloud

Mine are 8 feet long and haven't bowed noticeably in the 4 years they have been there. Other than pride of craftsmanship, would it matter if they bowed?

Re: raised bed gardening

#3

Maybe....

Barry Irby

Depends on the soil. If it heavy and dense they probably will. Perhaps its better to safe than sorry. I would be inclined to drive an angle iron stake at the center of each side and bolt it to the frame. I think the rod across the center would bother me. Digging rototilling and all.

Re: raised bed gardening

#4

JL

Re: raised bed gardening *LINK*

JL

I've been using the Lee Valley "corners". I rabbeted the short ends of my 4 x 8' bed so that the corners will work better. I can stack two 2 x 8" and get ~15" of raised beds.


I usually just tack a board on the outside if I have bowing.


Raised bed corners

Re: raised bed gardening

#5

Re: raised bed gardening

Howard Norman

Like you JL I used the Lee Valley corners. I used 1" rough cedar for my 4x8' raised bed. It has been there for five years and the cedar is holding up well. I used black rolled felt inside to help seal the insides of the raised bed. It isn't perfect but it does help.

Re: raised bed gardening

#6

Re: raised bed gardening

Scott in Montana

I had no trouble with the sides bowing but I had horrible troubles with the wood cupping. Where it didn't pull the deck screws through, the cupping action pulled them out. It didn't seem to matter which way the grain curved towards.

Maybe a piece of angle iron on the inside and the outside?

Best of luck!

Scott in Montana