Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Plastic or metal threaded rod?

Posts

Plastic or metal threaded rod?

#1

JL

Plastic or metal threaded rod?

JL

I've been asked to make a set of processional torches. The candles that they use are oil filled candles. They have a threaded socket (1/2" x 13 tpi) in the bottom.

I was thinking about drilling a 1" socket for the candlesticks. Then I thought about just using a threaded rod. Now I'm thinking about using both a socket and the threaded rod (or bolt). I figure if the candlesticks were screwed in, they wouldn't come off easily.

The candlesticks are nylon or some similar plastic. The thread is (as I said) 1/2" x 13 tpi. I can easily get metal 1/2" bolts or all-thread from the local hardware places. Should I consider trying to obtain plastic bolts or threaded rod or just go with the metal? McMaster Carr has nylon and other types of rod available at a reasonable price.

Re: Plastic or metal threaded rod?

#2

Quick & Done

Mark Mandell - Gone Round In Jersey

Drill 1/2" holes 1" deep in your torch ends.

Measure the depth of the candle sockets.

Cut the hexes of a couple of 2"x 12"bolts

Slice across the threads on the cut end (for better grip), then epoxy the cut ends into your holes leaving a stud that is less than the depth of the torch socket.

[I'd use plain steel rather than plastic/nylon so they can't get any fusing of plastic-to-plastic over time and use.]

Re: Plastic or metal threaded rod?

#3

Re: Plastic or metal threaded rod?

Carol Reed, Strawberry, AZ

Hi JL,

I have done this one several times. I used metal, threaded rod, in fact. Double nut the rod and thread into the staff, leave as much exposed as the hole on the candle is deep. Then remove the nuts. Once threaded on, there will be little reason to remove them, unless they are ceremonial candles and require special storage.

If they are Kerry candles, I think the material is UHMW and they do carry the connectors, in aluminum, as I recall. I didn't use those due to the expense and usually the client ordered the candles and I didn't interface with the vendor.

But since at the time I didn't live all that far from the vendor, I dropped by one day and learned a bunch about their candles. Good company.

One tip: On one job for Advent candles - only used one month out of the year,- the candles were disassembled from their stands and stored each year. I used a little beeswax on the metal threads to keep them from 'sticking.'

Oh, and be careful of cross-threading. It's easy to do with the steel stud into the candle base.

Re: Plastic or metal threaded rod?

#4

JL

Sounds like metal is a good idea then.

JL

Carol -that's why I was asking about using plastic threaded rod. I was worried about cross-threading. These are the 11" x 1" Kerry oil-filled candles.

Re: Plastic or metal threaded rod?

#5

Re: Sounds like metal is a good idea then.

Carol Reed, Strawberry, AZ

I had a threaded rd of HMWD that I tried. It was so 'sticky' that I felt the ladies who stored the candles would more than cuss me if I used it.

So I simply applied beeswax with the steel and showed them how to carefully put them back together. Never heard of a problem over about 20 years. Must have worked.