Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Concrete counter top polishing

Posts

Concrete counter top polishing

#1

Concrete counter top polishing

clay foster

What with winter weather and time spent making other stuff and teaching gigs, the polishing has been intermittent. A few more pin holes to fill and one last pass with the 3000 grit pad and it will be ready to seal. Unfortunately that won't be soon, since Jennifer and I are teaching a Turned For The Kitchen class next week at Marc Adams school of Woodworking. At least the cabinets it will go on are all finished.




Re: Concrete counter top polishing

#2

Re: Concrete counter top polishing

John Lucas

it's looking cool. I would have put ants next to each square. :)

Re: Concrete counter top polishing

#3

Beautiful!

Don Orr

Re: Concrete counter top polishing

#4

Ellis Walentine

The payoff

Ellis Walentine

All those hours of planning and fabricating and pouring and polishing are finally paying off, Clay. You're both to be commended for the heroic efforts. The result is stunning. Thanks for the update.

Ellis

Re: Concrete counter top polishing

#5

Re: The payoff

Jennifer Indy.USA

Now about this Kitchen Remodel that I hear is getting ready to happen at your place....Do tell! What'cha got planned?

I bet it's going to be great in that awesome home of yours.

Jen

PS: Clay's done all the hard work. I just supervise :)

Re: Concrete counter top polishing

#6

Yea-a-a-a,  What's Up Wit Dat Kitchen?

Mark Mandell - Gone Round In Jersey

I remember several people here offered to help and than silence.

C'mon, Boss. Let's Rock n' Roll!!

Re: Concrete counter top polishing

#7

Re: Concrete counter top polishing

Dick Coers

Curious, how are you going to polish the fillet from the top to the backsplash? Would you cast a seperate backsplash if you had to do it again?

Re: Concrete counter top polishing

#8

Re: Concrete counter top polishing

clay foster

I have some hand sanding pads that I've modified for sanding the fillet. It's a block of stiff foam rubber with diamonds attached to a cloth backing. I trimmed the foam rubber so it conforms close enough to the fillet radius.

If I had it to do over, I would do a one piece again. I would rather spend the time now making and polishing a one piece rather than spend the rest of my life grumbling about a hard-to-clean seam that will get grungy.