Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Inlay

Posts

Inlay

#1

Inlay

Greg1

I'm trying to restore a car steering wheel from the 1960s. It had a wood veneer inlay around the entire face, including a chrome strip on the ID and OD of the wood. The wood veneer is about 3/8" wide, and the chrome strip is about 1/16" wide. I can handle the wood veneer by cutting arched strips from a sheet of veneer, but am having trouble thinking of how to integrate the chrome strip. Any suggestions? Thanks.

Re: Inlay

#2

Re: Inlay

paul woolson

Could you not just purchase some chrome in the thickness you need and lay it on edge so the side is what you are seeing? Then it should bend around that curve pretty easily.

Re: Inlay

#3

Re: Inlay

paul in AZ

How about some specifics? Photo? Make, model?

Restoring steering wheels is a sub-specialty within the restoration game and can be quite tricky. There are a number of shops specializing in doing only that.

A better place to ask would be one of the collector car websites. Both of my collector cars have marque specific forum sites that are very helpful.

Re: Inlay

#4

Re: Inlay

Greg1

Laying a band on edge is kind of the right idea, but ..... Let's say the ID of the wheel is 18", and the OD is 19". A 360 degree band of chrome strip/wood weneer/chrome strip that's 3/8" wide goes from an ID of 18 5/16" to an OD of 18 11/16". I can handle the wood part, it is the addition of the 2 chrome strips that gets me. I must admit that while I have a lot of wood working experience, my experience with veneer is not quite a robust.