Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Drum sander project help

Posts

Drum sander project help

#1

Drum sander project help

Keith Misegades

I have glued up a small (20" X 40") make-up tabletop that I am making for my wife. This will eventually be cut down to about 18 X 36 to fit into a custom bathroom vanity.

I have belt sanded a few tops table in the past, some quite large, but have never gotten them dead flat like a drum sander can.

Can anyone recommend someone or a business in the Nashville, TN area that would drum sand my table top? I really don't have any idea how much this service would cost.

Thanks for your assistance.

Keith

Re: Drum sander project help

#2

In Western PA shop time is $50/hr.

Gary Smyth

Actual cost depends on the amount you have to sand and the width (max in one pass is 36") of the top. The cost was identical for two shops which are typical millwork/lumber yards. Our lead time around here now is one week to 10 days, but on simple "end of day" sanding I can generally pick it up in two or three days. My delivery and pick up. A top should take no more than an hour depending on the number of passes and the grits you want to use. Call ahead and get an estimate when they see the work. The shops I use generally start at 100 and then 150 grit. If it needs more I do it with a finish sander. Hope this helps.

Re: Drum sander project help

#3

Re: Drum sander project help

Dave Paine

In case you do not find a shop in your area, another option is to make a sled for the router.

I needed to re-surface a 30in x 5 ft laminated maple island top which was given to me. It had been sanded by the previous owner using a belt sander. Like you he did not own a drum sander.

Lots of dips and places where the belt dug deep.

I laid the top on a bench and shimed the corners to get a consistent height.

I clamped some scrap boards to the long sides to provide sufficient clearance for the dado bit I was using.

I mounted the router on two piece of angle iron whose overall length allowed the router to move between the two long sides.

Worked well. I did end up with some deflection in the middle, but overall was smooth enough to be able to finish with random orbit sander.

This was 8+ years ago. Getting time to re-finish due to wear and tear.

Next time I will consider making the sled from two pieces of Unistrut. This should avoid the deflection. Bolt a plate between the two Unistrut pieces to support the router.