Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Keeping silcone fresh in open tube

Posts

Keeping silcone fresh in open tube

#1

Dale Lenz

Keeping silcone fresh in open tube

Dale Lenz

It maybe a week to a month since I've use the silcone and it's always dries up a few inches down the nozzle. I've tried running a 3" drywall screw down the tip and leaving it there untill next use, wrap the nozzle opening with packing tape. The last several tubes of silcone I purchase the tubes with snap on caps and still seal with packing tape. Usually, to unplug will run a 3" drywall screw down the nozzle and pull out with pliers. Last night tried something different. Put a dab of silcone on my finger and sealed up the "cap joint" (?). Anyone found a sure-fire way to keep the silcone fresh inside the nozzle for next time use. I don't loose the remander(sp) of the tube, but it's a hassle missing it.

Re: Keeping silcone fresh in open tube

#2

Re: Keeping silcone fresh in open tube

Lee Schierer McKean, PA

I generally buy the brands with the replaceable caps. At first I wiped off any excess before putting the cap back on, but now I leave the excess so it squeezes out around the snap on cap. It cures and seems to seal the rest of the nozzle so it stays fresh longer.

Lee

Re: Keeping silcone fresh in open tube

#3

Re: Keeping silcone fresh in open tube

Joseph Mulherin

Dale, I have used the electrical yellow connectors on the ends of the tubes and leave some silicone around the edges which can dry out but is easy to remove....and the tube contents are long lasting.

Re: Keeping silcone fresh in open tube

#4

Re: Keeping silcone fresh in open tube

John Lucas

Dale I use it all the time for my hand mirrors. That means it sits for about a month or more between runs of mirrors. The best method I've found so far is to make a sort of fake lid. I wrap masking tape around the lid so it forms a tube about 1" longer than the existing tube. Then I bend over the top 1/4" and squeeze the silicone out into this. this is the part that hardens and maybe a little way down into the tube. I can usually grab the dried extension and pull out the rest.

I tried the screws, electrical connectors, and even caps from other things that would fit. None of them worked as well as the above.

Re: Keeping silcone fresh in open tube

#5

Re: Keeping silcone fresh in open tube

Randy

Not sure if it will work for silicon but I put masking tape on tip of 5200 and store in the refrig, lasts for months that way.

Re: Keeping silcone fresh in open tube

#6

Re: Keeping silcone fresh in open tube

FredD

Using a Blue or Gray Wire Nut for a screw on cap works like a charm, at least for me.

FredD

Re: Keeping silcone fresh in open tube

#7

Dale Lenz

Re: Keeping silcone fresh in open tube

Dale Lenz

Thanks, folks. Seems my problem has been I'm too darn neat, always clean the silcone tip. Will try Lee's method first since I have a capped silcone tube. Might eventually down grade to the cheap stuff w/o caps and try the tape and silcone push-out. I've not had luck with the wire nuts, but have always cleaned the silcone nozzle first. Humm...fight fire w/ fire.

Re: Keeping silcone fresh in open tube

#8

Re: Keeping silcone fresh in open tube

Jim Dillon

Dale,

Sometimes I have had luck jamming the nozzel into a container of "wax" from a toilet bowl ring, followed by a piece of duct tape.

Jim