Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Cutting Crown Molding

Posts

Cutting Crown Molding

#1

Cutting Crown Molding

Doug Reynolds in Seattle

I am cutting crown molding to go around the top of a small box (18" x 12") on the table saw with a home-made miter sled. Does it make any difference which side of the molding goes up given the molding is sort of wedge-shaped? By that I mean, the side that goes up and is flush with the top of the box is wide - about one inch, and the side that goes toward the feet is only 1/4". TIA as this about finishes my project.

Re: Cutting Crown Molding

#2

Re: Cutting Crown Molding

FredD

sounds good to me , a conventional Crown mold goes Cove and or Ogee up, but this isn't conventional.

FredD