Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

out door stuff using trex

Posts

out door stuff using trex

#1

out door stuff using trex

woodenleg

My wife and I are wanting new outdoor tables and chairs, is it possible to build using the plastic and wood planks, like Trex. We do not have storage room for outdoor furniture and I was thinking about using composite planks. Will it work? I also have to think about weight. Thanks, Dave

Re: out door stuff using trex

#2

Re: out door stuff using trex

Mark Mandell - Gone Round In Jersey

Keep in mind that Trex is Not structural. No span over 18". It also absorbs water and will swell, although not as much as wood.

Re: out door stuff using trex

#3

Re: out door stuff using trex

Barry Irby

I am with Mark on this. The stuff is pretty rubbery. I think the span is actually supposed to be 16" or less. And it heavy and expensive.

I would rather have Ipe or Mahogany, or some of the thermally modified stuff.

Re: out door stuff using trex

#4

Re: out door stuff using trex

Bill Howatt

I have Trex decks and think they are great. Somewhere around 6 years old and looks just like the day I installed it.

However, I don't think it is a good choice for your project because of its lack of structural strength and weight.

Bill

Re: out door stuff using trex

#5

Re: out door stuff using trex

Todd Nebel

I have started to see a lot of this recently here in Pennsylvania. All kinds of outdoor furniture, chairs, tables, gliders, rockers, etc. It is Trex-like, but I don't think it's actually Trex. I found the prices of the chairs vary, anywhere from $200 to $400 for the same style chair. Even saw it being sold in the King of Prussia mall and at a Mennonite's hardware store. If I see them for $200 again this spring I will be buying 2 adirondack style chairs.

Now a warning. I built 3 steps off my back door down to a patio using Trex and I mitered the corners of the risers as I wrapped each step. These were some of the best and tightest miters ever! Do you know that the Trex shrank a solid 1/8" along it's length! Soooo disappointing.

Re: out door stuff using trex

#6

Re: out door stuff using trex

Dave Paine

I replaced a section of decking over my garage with the Lowes ChoiceDek.

I am happy with how this is performing. It is thicker than Trex and so far feels to support my weight. This is a walkway so only get passing weight.

I made a cover for a septic tank access hole in Trex. This was 2ft x 2ft. No weight, just keeping out the bugs and critters. I screwed supports in below.

After 1 summer this warped so much it pulled out the screws. I have to re-drill.

Still is shows severe bow. Perhaps over 1 inch over this short 2 ft stretch.

I have to agree with the other replies. If used as decking it may work, but as furniture, I do not expect you will like the results.

If you really want to experiment, try the Lowes ChoiceDek.

If you want real wood, consider the tried and true white oak. Used for barrels and how many whiskey barrels have you seen which failed during use?

Re: out door stuff using trex

#7

Clint Searl

Think Ipe

Clint Searl


Re: out door stuff using trex

#8

Re: out door stuff using trex

George Koch

Personally, I would stick to common, known to be rot resistant, light and strong western red cedar. Wooden legs an all! George

Re: out door stuff using trex

#9

Re: out door stuff using trex

Dave Bair, Eaton Rapids, MI

Trex gets really, really hot in direct sunlight.