What size holes for wine rack
OneDayJD
I'm building a kitchen island/butcher block table. Under the table top I am putting a wine rack between the legs. Basically going to take 1x4s (or 1x6s?) and use a drill press to cut holes down the board, then rip it in half to have the semicircle "cradles" for the bottles. My question is: for a standard wine rack like this, what size hole saw bit should I use for the butt end of the bottle (back) and for the neck (front) of the bottle? Also, is there a rule of thumb as to how much I should space the front and back boards from each other? Thanks for any advice!

.
I usually feel uneasy unless I have at least 4 - 5 cases on the rack downstairs.


