Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Saw stop fence curved at ends

Posts

Saw stop fence curved at ends

#1

Saw stop fence curved at ends

Mitch from Canada

Hi all,

I've had a Saw Stop Industrial for awhile and was looking at the fence th other day. Both ends of the melamine fence sides curve out away from the fence just past where they are supported by the steel centre support. It's more than .005 of an inch at each end. Didn't get the exact measure but a .005 feeler gauge slipped in easily. Anyone else notice this?

I "might" be able to straighten them out by tightening the crap out the end screws. Screws are about an inch from where the curve happens. Other solution I thought of was cutting off melamine sections that protrude past steel support centre. Any other thoughts are appreciated.

Just curious if this was the norm with Bes fences? I had an old Delta Unisaw with a Unifence before this one and never had this problem.

Thanks.

Mitch

Re: Saw stop fence curved at ends

#2

Re: Saw stop fence curved at ends

Dave Bair, Eaton Rapids, MI

My PM fence has that low-friction plastic facing (forgot the initials that define it) that has a dip in the middle that was a good deal larger than .005". I shimmed it out to about .006" (the best I could manage) and use it with no problems.

Re: Saw stop fence curved at ends

#3

Re: Saw stop fence curved at ends

Mitch from Canada

Thanks. I might have to try that shim idea.

Mitch