Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Router Table "Sub Top"

Posts

Router Table "Sub Top"

#1

Router Table "Sub Top"

AZ in Colorado Springs

Last Christmas I received a cabinetmaking router bit set -- rail & stile bits, and a panel raising bit.

Well, I needed a beefier router than my little Skil router and I got the Freud FT3000VCE w/ 3-1/4 hp during a great sale at Woodcraft. I have a Rockler router table (with the large opening in the router plate), and last Friday I fitted the Freud router to the router table insert. This is great -- I now have a powerful router and a much better height adjustment mechanism from above the table (instead of a bottle jack positioned below the router, which worked OK).

Well, I still have a problem: the panel raising bit is about 3/16" wider than the opening in the router table insert, even without any throat insert installed. With the router raised all the way up, I can safely install the bit on the collet (it won't be inserted only partially into the collet).

At the wood skills shop at the Air Force Academy, where I volunteer every weekend, we have a Rockler router table with the smaller opening, and a Freud router table, and the panel raising bit is too large for that router table as well. So, no joy just using a router table there.

So, I'm thinking I'll need a 1/4" or 1/2" (not certain yet how much additional height I need) sheet of melamine coated particle board, clamped at the back and secured toward the front with double sided tape. I'll cut a hole about 1/4" wider than the bit, and I can clamp the fence to the table in lieu of using the T-track and t-bolts. Slowest speed setting on the router, of course, and little incremental bites on multiple passes.

Am I missing any lifesaving details?

Re: Router Table "Sub Top"

#2

Re: Router Table "Sub Top"

Gary Smyth

Don't use clamps and double sided tape. If you are set on a added top, drill as many holes (at least four) as you need in the new top through the old and countersink. Attach it with flat head machine screws. Lock it on with wing nuts from underneath the original table. Do not assume that a big bit traveling at even the lowest speed will not cause the tape to fail or clamps to shift. If it does the whole table may take off. Be safe. That big bit will and should scare the heck out of you. In addition the advantage is that you may be able to have a slightly larger table. Look before you drill. Make sure that the original table will have room for the screws underneath. Some tables have metal "flattening" webs underneath and you don't want to drill through those and you need clearance for the wing nuts.