Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Sort of OT - securing a work bench top?

Posts

Sort of OT - securing a work bench top?

#1

JL

Sort of OT - securing a work bench top?

JL

As part of my new duties as Sexton of our church - I get to "furnish" the sexton's "closet". As part of our remodeling - the sexton now gets a small room (~10' x 7') for storage and such. I brought over some of the old melamine covered particle board cabinets from the old kitchen. They were in storage. Anyway, I cleaned them up and put them in the closet.

We have a couple of fairly solid slab doors from the old parish hall. One of them was not drilled out for a knob set. I was figuring on using it for a work bench top. It is ~36" x 80" or so. I'm not adverse to cutting it down.

I was figuring on using it for a "work bench" top for the sexton's closet. The base cabinets have somewhat "solid" tops (particle board coated with melamine). The cabinets are ~24" deep.

Should I secure the door slab to the wall using cleats of some variety or secure it to the base cabinets? Should I cut the door slab down and if so, how much?

Re: Sort of OT - securing a work bench top?

#2

Re: Sort of OT - securing a work bench top?

Dave Tenney

Just take yer framing nailer and toenail it to the wall ;)

If you have cabinets to secure it to, and they are the right height I would use those. That is generally the way it is done in casework. Otherwise put a rim board on the wall and set it down on it. You can lay down a bead of 100% Silicone and skip metal fasteners altogether. Hard to really visualize without a picture, but one way is usually more obvious that another. As far as size goes, many counter tops are 24" wide but anything goes.

Dave

Re: Sort of OT - securing a work bench top?

#3

Re: Sort of OT - securing a work bench top?

Dave Bair, Eaton Rapids, MI

I used 2-inch iron angle. It's attached (using lag bolts) directly to the base and to the top using a 4-inch "batten". Use a narrower batten if a wider one elevates the top too much for your liking.

Re: Sort of OT - securing a work bench top?

#4

Re: Sort of OT - securing a work bench top?

Gary Smyth

I find a 30" to 32" deep, and 42" high top more to my liking. Let it overhang the cabinets and you will have some edge clearance to clamp something down if you need to. Let gravity do the work to hold the top down to the cabinets underneath (especially if you have to build up the cabinets to get the "bench" the right height). If you feel it necessary to hold the wall end down to keep from tipping, install a long 8 or 10 outlet power strip along the back and attach it to the wall. Make the height so that you slide the top underneath the powerstrip with maybe a 1/16" clearance and you will have to pull the top forward to remove it. Rarely will that be necessary, but it will give you the option. This way you will have ample power, cabinet storage, clamping area and a work top all in a bundle.