Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Cutting "Man Made Granite /Marble

Posts

Cutting "Man Made Granite /Marble

#1

Cutting "Man Made Granite /Marble

Mark

Has anyone ever cut this stuff? It is a man made material that is used to fabricate one piece vanity tops with the built in lavatory. I am told from the plumbing supply that you use regular wood cutting power tools to cut it.

I am buying a 2'x 4' slab for a laundry room counter top

This stuff looks and feel like solid stone but is some kind of "pour" with a very hard gel coat top.

Any experience?

Seems to good to be true as the look is great, cost is a fraction of granite..and it workable.

In Canada its made by and known as Mr Marble.

Re: Cutting "Man Made Granite /Marble

#2

Re: Cutting "Man Made Granite /Marble

Paul Blackwell

I've cut Corian which is a man-made material. I made a serving tray from the cutout for the stove top. I just used a carbide blade in the tablesaw, and also in the router to cut a groove around the edge of the piece. This was 1/2" thick material, and other than using a slower feedrate, it was no problem to machine.

Re: Cutting "Man Made Granite /Marble

#3

Moses Yoder

Re: Cutting "Man Made Granite /Marble

Moses Yoder

Corian is a type of plastic I think, different from the faux marble that Mark is talking about. We have cut lots of corian with regular woodworking tools and routed parts on our cnc router with a slightly slower feed rate than regular wood parts. I have never cut those faux marble vanity tops but have installed a few. I would probably put a cheap or old saw blade in the saw and see what happens. It should probably be a fine tooth like 40 teeth or so crosscut blade, not a coarse rip blade. You want a feed rate fast enough to make chips, not so slow that it heats up and melts the plastic and gums up the blade.

Re: Cutting "Man Made Granite /Marble

#4

Re: Cutting "Man Made Granite /Marble

Barry Irby

If you are talking about Corian or one of the similar high density plastic materials, I think you can cut it with regular woodworking cutters and blades with no problem.

If you are trying to cut "cultured marble" which is a mix of marble dust in some sort of plastic binder, I am not so sure. I have cut it with an abrasive blade, but never tried a saw blade. I suspect it will be very dusty and tend to ruin the blades and cutters quickly and may infiltrate bearings and wear surfaces. Not what I would want to do on my machines. Use borrowed machines and you may be fine. Until they find out what you did.

Re: Cutting "Man Made Granite /Marble

#5

Re: Cutting "Man Made Granite /Marble

George Koch

Mark, I've cut many of the cultured marble vanity tops to length by using a diamond blade in a circular saw, cutting from the back side and out of doors because of the dust created. The cut cannot be polished to become a finished end or edge. As others have said, if it's a more plastic product, like corian, it can be be worked with normal woodworking blades an bits. George

Re: Cutting "Man Made Granite /Marble

#6

Re: Cutting "Man Made Granite /Marble

Hal

If you're talking about the cultured marble, I used a masonry blade in my table saw and it worked fine. This was on the advice of the manufacturer. Dunno about routing an edge, but I think it likely a regular carbide tipped bit would likely work. Good luck. Hal