Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Been away for awhile....

Posts

Been away for awhile....

#1

McKinneyMike

Been away for awhile....

McKinneyMike

Howdy all! It has been quite awhile since was last around these forums. I have been into shooting rifles for the past several years and got away from the woodworking. I needed a break from wood for awhile.

Anyway over the holidays I got the itch to get out in the shop, as I need to build some reloading benches, for my newly completed reloading room. Well, it's not quite finished, as I still need to get the base molding installed along with door casing.

It had been over 4 years since I really had turned any of my stuff on. Worried that it would not still work, but thankfully it was all fine :)

Anyway here are some photos of the reloading bench bases that I built for my new reloading room. I had a fair amount of 6"x6" Redwood beams that I cut down to 4"x4" pieces for the legs on both benches. I had some 5/4 Ash that had a lot of darker wood in it, that I would have not have used to build furniture, so I used that for the aprons and stretchers.

The longest bench is still waiting for me to get some curly Maple cut and routed so that I can install it and then laminate a new sheet of Formica to it. I will then chamfer the edge and trim the laminate at the same time. Well anyway here they are and hope to be able to do some more stuff again shortly. Forgot how much I love getting out in the shop. Good to see some familiar old faces around here too!

Mike Mastin










Re: Been away for awhile....

#2

Re: Been away for awhile....

Ken Oakley-Sunny St. Cloud, Fla.

Looks like you are reloading Atomic bombs

Re: Been away for awhile....

#3

McKinneyMike

Re: Been away for awhile....

McKinneyMike

Most reloading benches have 4x4 pine legs. I just did not want to build more "me too" benches :) They are really pretty lightweight.

Re: Been away for awhile....

#4

Re: Been away for awhile....

Galen Vetterick

Nice benches, but my RCBS press, lube/sizer and powder measure all bolt close to the bench edge and your apron looks like it would not allow that. Maybe you have another station for these? Maybe a threaded insert in the apron?

I found 4 x 4 legs made it hard to level on my uneven concrete floor. Not fancy but they just set on a pair of shims.

I always built benches so they can be broken down into sections to move them. Seems nothing is ever that permanent in my life to make things that fancy.

Re: Been away for awhile....

#5

McKinneyMike

Re: Been away for awhile....

McKinneyMike

I installed T-nuts and large headed carriage bolts for leg levelers on each leg. They work super for this.

I have been here in this house for 22 years now and don't see me leaving for at least another 20, God willing :) These benches are light enough that I carried each of them upstairs and installed them after the tops were removed. They are really quite light weight.

I use a Forster Co-Ax single stage press. It requires very little pressure to resize and seat vs most any other press that I have ever used. Makes the straightest ammo (almost zero runout) as the shell holder floats. The Co-Ax is mounted on the smaller of the two benches. Front bolt holes are 1 1/4" and back are 3 1/2" from front edge of press. It actually straddles the apron, but the bolts barely stick thru the bottom of the table top. You have to get down at top level to even see them. This press does not require brute force like most C or O press style presses do.