Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Long - Help me spend my money - 14" Bandsaw

Posts

Long - Help me spend my money - 14" Bandsaw

#1

Long - Help me spend my money - 14" Bandsaw

Joe Pack

I am considering adding a 14" bandsaw to my already crowded basement workshop

I already have a 17" 2hp Grizzly with excellent quality 3/4" Timberwolf blade that does all my heavy cutting/resawing/ripping, but a lot of the craft show type work I find myself getting into requires finer cutting than can be done with my current 17" setup. Yes, I can change the blades, but that requires more time setting up the saw than cutting with it.

If I add a 14" saw, I will set it up with a Carter Stabilizer single guide system and a 3/16" blade and leave it pretty much set. That way I can do my heavier cutting on one saw and do the smaller, finer work on the other without wasting time on repeated set-ups.

Because I already have the large saw, I don't need the "best" or most powerful or most expensive 14" saw. I have pretty much narrowed down my search to 2 (3?) saws. These are the Grizzly 0555P that I can buy for a total of $499 and the Delta 28-206 that I can buy for $540. (A similar Jet is also available, but in the low $600 range).

Both are 1hp, can use a 6" riser if needed, and both have 4" dust collection outlets.

The Grizzly has Carter-style bearings, the Delta uses cool blocks (however neither of these will be used with the Carter Stabilizer, so that is a moot point for my intended use).

The Grizzly is open stand, the Delta is closed (but many reviews on Amazon refer to a severe vibration in the Delta, most due to warped stands).

The Grizzly includes a very good quality fence system and "okay" miter gauge while neither is included with the Delta. I may not need them often, but they are included with the Grizzly, and can be used on other machines or tables if I need them.

The Grizzly has to be shipped, then assembled. I can pick up the Delta directly from the floor already assembled but spend $40 in gas going to get it.

I have been completely satisfied with my 17" Grizzly and with their customer support (other folks' mileage may vary on the support issue). Still, with Grizzly I have to worry about damaged or defective parts and dealing with a company 400 miles away, while the Delta dealer is only an hour away and is highly respected in our area.

What to do, what to do????? :( :( :(

You get the idea. Thanks for letting me ramble and think this through. And thanks for any opinions, rambling or otherwise, that you might wish to share!

Re: Long - Help me spend my money - 14" Bandsaw

#2

Re: Long - Help me spend my money - 14" Bandsaw

Howard Norman

Assuming the quoted Grizzly price is FOB your home I would probable buy the Grizzly. Here in AZ I would have to pay sales tax if I were to buy the Delta which is close to 10% here in AZ. In my experience if there are any problems with the Grizzly due to shipping they will make it right quickly.