Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Does This Sound Like A Belt Issue?

Posts

Does This Sound Like A Belt Issue?

#1

Does This Sound Like A Belt Issue?

Steve in Phoenix

I installed a brand new Amana A.G.E. 80 tooth crosscut blade, and a strange thing happened. In the test crosscuts, the leading 1/3 edge is considerably less than 90 degrees, and the following 2/3 is dead on. I checked the blade runout, looks fine. Then I remembered I always used a blade stabilizer on the thin kerf blades (so I never saw the problem). I added a stabilizer to the Amana, and the "problem" is 98% solved.

I have aligned the pulleys in the past, so I'm thinking it may be the belts. But can the belts cause so much vibration in a full kerf blade?

Thanks

Re: Does This Sound Like A Belt Issue?

#2

Re: Does This Sound Like A Belt Issue?

del schisler

Doesn't sound like a belt to me. I guess to answare your question get a new belt. I use a link belt. If you haven't tried this kind of belt. I wouldn't use any other kind. So much smoother on start up. The amana blade should be a good product. 98 percent good only leve's 2 percent Very small amount off ?? On rips

Re: Does This Sound Like A Belt Issue?

#3

Re: Does This Sound Like A Belt Issue?

Dave Bair, Eaton Rapids, MI

Actually, it sounds like a miter-slot/ miter gauge issue. It appears your setup is giving variable results and the variable is the changing position of your miter gauge as it slides down the slot.

Re: Does This Sound Like A Belt Issue?

#4

Re: Does This Sound Like A Belt Issue?

Steve in Phoenix

I checked the miter gauge, and tweaked it a hair. I also aligned the pulleys and tightened the belts. I think I will need to break down a buy some of the link-belts, and see how that works.