Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Mounting barrel hinges

Posts

Mounting barrel hinges

#1

Mounting barrel hinges

doug f, san clemente, ca

I'm making a ring box for my son (bucote with an oil finish.) I found some really small barrel hinges, just a little over 1/8", that work really well.

My concern is fastening the hinges to the box. I've thought about epoxy, CA or maybe duct tape. What I'm afraid of is getting any adhesive on the knuckle of the hinges.

Anyone have any helpful hints on getting those little suckers to stick and still work?

Thanks.

Doug


Re: Mounting barrel hinges

#2

Re: Mounting barrel hinges

Ralph Lipeles

I would use epoxy and overdrill the hole depth so that any excess epoxy is pushed away from the hinge rather then being pushed back up. Also, glue in 2 sessions. The base then the top. This will allow you to always have the hole facing down so that you will not have any epoxy running into the hinge by gravity.

Ralph Lipeles

Re: Mounting barrel hinges

#3

Re: Mounting barrel hinges

charlie belden

The barrel hinges I have, think they're Blum or Gross, have a small screw in each part that spreads the part that goes into the hole and locks them in place - no glue needed.

Re: Mounting barrel hinges

#4

Re: Mounting barrel hinges

Lee Schierer McKean, PA

I've used these hinges on several projects. I use a medium viscosity superglue from Rocklers, I use a tooth pick and run a bead around the inside of each hole and then immediately push the hing into the hole. No glue gets on the pivot. I always drill my holes first and then trim the wood to 47 or 48 degrees until the edge of the cut bisects the hole. I achieve the 47 or 48 degree angle with a standard 45 degree router bit and place a bit of tape on the side of the piece away from the cut to raise the edge up off the table surface slightly. The more than 45 degree angle lets the lids stay open better because they open past 90 degrees.

Lee