Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Jig finishes - ya'lls favorites?

Posts

Jig finishes - ya'lls favorites?

#1

JL

Jig finishes - ya'lls favorites?

JL

I usually just wipe on some BLO/Poly mix. I usually wax the rubbing surfaces. I usually don't stain them.

I've been busy making a router mortising guide from Bill Hylton's plans in one of his books. It is all hardwoods - albeit of some quite dissimilar scraps (maple, oak, cherry, soft maple and poplar).


So I realized that I have a finishing "opportunity". I have some oil finishes left over from a project or two (Tried and True Danish Oil Finish and some Nordic Oil from General Finish as well as tung oil and BLO). I have some polyurethane (gloss) and some poly/BLO mix. I even have some shellac flakes somewhere.

The keys and the key ways will be waxed, of course. I'm even willing to try a few different finishes on this project. I figure I have the vertical holder, the horizontal holder, the router stops and the different surfaces of the jig itself.

What is the general opinion for finishing the other surfaces?

Re: Jig finishes - ya'lls favorites?

#2

Re: Jig finishes - ya'lls favorites?

Bob Entwisle in NJ

Hi JL

If I finish them at all, I'm kinda partial to shellac for jigs, one or two coats protect the wood, and then I can add more if I've got the time or inclination. I also like a BLO,Turps,Varnish mixture, probably because it smells good.

For tool handles straight BLO.

Here's one I've only tried on a test piece, flood with poly and wet sand the poly into the wood. The results on my test piece were promising, but I never followed up with it. So that is one I might try on a jig.

Mortising jig, sounds like a winner, which one of Bill Hyltons books is the plan in?

I could do with a mortising jig.

Bob in NJ

Re: Jig finishes - ya'lls favorites?

#4

JL

Re: Jig finishes - ya'lls favorites?

JL

Woodworking with the Router.

I got it on sale a while back. I've been reading it and decided to try a couple of the jigs.

Re: Jig finishes - ya'lls favorites?

#5

Re: Jig finishes - ya'lls favorites?

Bob Burnet (NW FL)

I believe the name of the book is "Router Magic" - look on page 124. If you Google for Router Magic and look on the Amazon site, you can do a preview of the book. I finished mine with a 33% mix of BLO, Poly, & turp with a few drops of japan dryer.