Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Electric motor questions OT

Posts

Electric motor questions OT

#1

Electric motor questions OT

Barry Irby

A friend was asking me about his trash compactor. He says the motor runs in one direction until it hits a limit switch and then it runs in the opposite direction until it hit the other limit switch. Up, down, up down. My friend says there is a centrifugal switch on the end of the motor and he is sure it is the centrifugal switch that reverses the direction. He says that sometimes it fails to reach the limit switch and does not reverse and won't start again until he manually turns the mechanism and jacks it up or down to the limit.

Does anyone know how this thing works? Is it really the centrifugal switch that reversed it? Any suggestions on what to do to make it more reliable?

Re: Electric motor questions OT

#2

Re: Electric motor questions OT

Galen Vetterick

The centrifugal or speed switch only cuts out the circuit to the clockwise and counterclockwise coils to provide the momentary run in either direction. Don't think that would do what is happening. all units are probably wired different so he needs to check the wiring diagram in the manual to the unit. The one I had only had one limit switch and an interlock. There was also a torque overload on the drive worm. Could be a lot of things if contacts are bad in any of the switches. The diagram should show switch postions to check. Could be by manually cranking he is resetting the mechanical overload. May need drive lubricated.

Sorry cannot be more help unless he has the diagram to match the unit.