Dust collection and fluid mechanics
Bill Tindall
Now there is an off-putting title. But in spite of it I attended the woodworking club meeting only half curious as to what I might learn about dust collection I didn't already know. I was not optimistic. Wrong!

This is how I used to pick up dust, in this case while sanding a small piece. (Large pieces get done out doors.) The arrangement was based on numerous flawed notions about how to move air from the sanding block to the hose.
What I learned: In this case a significant amount of air going down the pipe is coming from behind the face of the pipe. Well, that is useless. Additionally, and non-obviously, the kinetic energy of the air pulled from behind is reversed when this air is turned around to go down the pipe. The process wastes energy, in this case in the form of pressure drop, the bane of dust collection.
This picture shows how to properly pick up dust. 
When terminating a pipe it would best terminate in something shaped like a trumpet end. Now all the air must come from in front of the pipe and none has to have its kinetic energy reversed. This arrangement has little to no pressure drop and vastly more useful air (from the thing being sanded) goes into the pipe. I was astonished how much better it worked even with this crude arrangement.
Now, if companies that sell dust collection stuff understood these principals we could buy inexpensive trumpet shaped terminations for our pipes. (Is someone at Lee Valley listening?) (Oneida does, but their trumpets are "gold plated" when plastic would do.)





