Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Hex shank forstner bits?

Posts

Hex shank forstner bits?

#1

Hex shank forstner bits?

Phil Joines

I need to get a 1 5/8" Forstner bit and extension. After fighting with slippage in various extensions I want hex shank on both. Anybody know a supplier?

I don't want the Colt Maxi Drive they're WAY over priced. #40 for one Bit? I don't think so.

Re: Hex shank forstner bits?

#2

Re: Hex shank forstner bits? *LINK*

Dave Peebles Lyons, Ohio

Hi Phil,

I bought a few from Lee Valley a few years ago. It looks like they still carry them. It says that the larger ones have the hex shaft you are looking for. I also found a hex bit extension made by Greenlee at my local big box store. I think it was in the electrical tool section.

Be sure to go through Woodcentral if you decide to buy them at Lee Valley.

Best wishes,

Dave


Lee Valley

Re: Hex shank forstner bits?

#3

Re: Hex shank forstner bits?

del schisler

i grind a flat on each side . That works for me. I do that on my tappered drill bit's . Never slips again ?

Re: Hex shank forstner bits?

#4

Lee Valley

Bill Tindall

The bits I got from Lee Valley were hex. The Colts may be over priced for your application but I watched a demo where a hole was bored lengthwise through a 30" log in about a minute. If I was doing any end grain boring I would consider these bits.

Re: Hex shank forstner bits?

#5

Re: Hex shank forstner bits?

Bill Howatt

I use LV hex shank bits and got a Milwaukee hex extension at HD.

Bill

Re: Hex shank forstner bits?

#6

Ordered the bit from LV

Phil Joines

Too bad they don't carry the extensions.