Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Tenon musings

Posts

Tenon musings

#1

JL

Tenon musings

JL

I typically use loose tenons. I can set up my plunge router and cut mortise rather easily. When I use loose tenons, I typically make my mortises either 1/4" or 3/8" wide by a "reasonable" "height" depending on the apron size.

So - I figure for a 1 3/4" x 1 3/4" cross piece and a similar size leg, I should have a tenon that is ~1/2", right? That shouldn't matter if I have a loose tenon or a regular tenon.

So what would be a reasonable "height" for the tenon on that size piece of lumber? I won't got into what would be a reasonable length of tenon - I figure that will be whatever the traffic will bear (~1 1/4 - 1 1/2" in each side).

Thoughts? Opinions?

TIA

Re: Tenon musings

#2

Ellis Walentine

Double tenons *LINK*

Ellis Walentine

If I read you correctly, you're talking about a table base made of 1 3/4" square legs and rails? If so, I'd use dual 3/8" x 1" (in section) tenons, spaced down 3/8" from the top of the legs.

Just my 2�,

Ellis


Similar situation

Re: Tenon musings

#3

JL

Thanks.

JL

That's answers the question quite nicely.

Re: Tenon musings

#4

Like this?

Bruce, a MN Galoot

I used a router to cut the mortises with the wood held in my usual router jig (a la Tage Frid's books). I don't have a hollow chisel mortiser - maybe someday. The tenons were cut on a table saw with a tenon jig. Maybe I could have done it by hand, but not with as many as I needed to cut for the cabinet - 8 sets. Both the rails and legs were 1.5" square.