Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

help bubbles in finish

Posts

help bubbles in finish

#1

help bubbles in finish

mreagan

I'm finishing a coffee table for the wife. The top is a large slab of paduak that was given to me. I sealed it with shellac and have two coats of water-based poly by zinsser. there are fine bubbles in the finish that I cannot seem to prevent despite changes in speed application or brush angle. Is this normal for water based poly, (I tested oil and it took days to dry...)? is this preventable and how. Thanks.

Matt

Re: help bubbles in finish

#2

Re: help bubbles in finish

Howard Acheson

What is the temperature in your finishing space?

Re: help bubbles in finish

#3

Re: help bubbles in finish

John Lucas

Try thinning the finish a little. I had that problem when I finished a table in the living room of my house. I thinned the finish a little and it got rid of 98% of the bubbles, then I poked those with a needle to pop them.

You didn't say what brush you were using. Use a good quality brush.

Re: help bubbles in finish

#4

Re: help bubbles in finish

Joe Mohnike

Was the shellac de-waxed, if not that may be your problem.

Joe M.

Re: help bubbles in finish

#5

Re: help bubbles in finish

Bartstar

What type of brush are you using? I have had great success with using just a foam brush when applying WB poly. I have noticed that it works best to lay the brush fairly flat when applying to get a smooth coat.

Regards

Bart

Re: help bubbles in finish

#6

Re: help bubbles in finish

Dave Bair, Eaton Rapids, MI

I always get bubbles in poly when I use any kind of brush, bristle or foam. I now apply poly using a folded pad of cheese cloth and thin the poly by 1/3. This applies a very thin coat of finish that releases any bubbles and dries in 2-4 hours. You'll have to apply about 5 coats of the wipe-on to equal one coat of brush-on, but you'll get a bubble- and dust-free finish without a lot of hassle. Incidentally, I sand lightly with 320 grit after every 5 coats or whenever I let the finish dry for more than 24 hours.

Re: help bubbles in finish

#7

Re: help bubbles in finish

mreagan

Thanks for the help guys. My basement temp is 68. I use the synthetic brush from wooster - the higher end one from home depot. The shellac was zinsser spray-on (oops); I'll switch to the seal coat non-wax version next time. I'm going to try sanding out the bublles with 320 grit and trying a final coat or two of poly gel varnish wiped on as mentioned in a recent FWW article. man I hate finishing...

Matt

Re: help bubbles in finish

#8

Re: help bubbles in finish

Steve Schoene

The Zinnser aerosol is dewaxed shellac so thats not your problem. A little thinning may help, but most waterborne finishes shouldn't be thinned more than 5 or 10 percent.