Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

gluing drawer technique to ensure it fits

Posts

gluing drawer technique to ensure it fits

#1

gluing drawer technique to ensure it fits

Bill Tindall


The problem is how do you glue up a drawer shaped like this and have some hope it fits well in its opening. Well, this is one of a multitude of problems arising from making drawers for a bow front chest. Fortunately, I learned a technique for gluing drawers at the Headley shop where I took a class (I hate to sound like a broken record on this topic, but I learned so much in this class) . Glue the drawer where it goes. Its Duh! simple.


Wedges on each side front and back, and on top provide the "clamps" holding the drawer securely in place and centered while the glue dries and renders the drawer stiff. The only requirement is that the dovetails are not fitted so tight that the drawer will not flex to accommodate the shape it is wedged to, and stay there.

I make drawers fit fairly tight and then plane them to get the clearance required. These appear to have huge gaps top and bottom because the drawer front has been rabbited to accept a cock bead not yet installed.

Re: gluing drawer technique to ensure it fits

#2

Thanks Bill, another "Doh" moment!

Jesse Cloud

Why didn't I think of that?

Dohhhh!

Re: gluing drawer technique to ensure it fits

#3

Re: Thanks Bill, another "Doh" moment!

Don Orr

Great idea Bill. I'm curious if the wedges cause any damage to the drawer or carcase. I'm assuming they don't or you would not use them. Beautiful work so far.

Re: gluing drawer technique to ensure it fits

#4

Re: Thanks Bill, another "Doh" moment!

Bill Tindall

they are only driven in sufficient to hold the drawer centered. So there is little force on anything. The putty knives were extreme. I forgot to put the plastic shims on this drawer's sides in front and worried the drawer might glue itself in. There are bigger wedges in the back as I size the back of the drawer 1/16" smaller than the front. the front initially fits the opening with little clearance. I plane the drawer for clearance later. Planing cleans up the dovetail glue, pin ends, etc. and makes it all "look pretty". If the drawer opening is a bit catywampus I can plane the drawer to still get a perfect reveal all around.