Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Installing cockbead question

Posts

Installing cockbead question

#1

Installing cockbead question

Bill Tindall


Shown in the picture is a preferred way to install the cockbead on the sides of a drawer so as to not hide the dovetails. Cutting the cockbead pieces is a bit tricky but cutting the groove in the drawer for the bead is not- a straightforward table saw operation.

How would one make the cut-out for the cockbead on the drawers ends (as shown) with a bow front drawer? The drawer can't be simply run over the table saw face down because the face down is curved/bowed.

Re: Installing cockbead question

#2

Re: Installing cockbead question

Barry Irby

Two thoughts.

Use a dado blade and run the drawer with the side fault on the table of the TS.

Or If you have the cut off that dropped off the face of the drawer when you cut eh curved front, tape it back on and run that on the table. This assumes you can make the alignment accurately and that the curvature is not so great as to raise the drawer front too high to reach with the TS blade. (Might have to put your ten inch blade back on momentarily.)

I suppose you could do it with a bandsaw, but I am not on good enough terms with my bandsaw to take a shot at it. I wish I found my bandsaw to be as useful and friendly as others here seem to.

Re: Installing cockbead question

#3

Re: Installing cockbead question

Keith Newton----Little Rock, Arkansas

The only time that I have used it, I milled the bead on a trim piece applied to a veneered drawer, so it was proud of the face by the radius.

I have several router bits with a bearing on the bottom, which would work, with the motor axis from the edge rather than perpendicular to the face. Climb cut, stop short of corner, finish with a chisel.

However, you can use that same bit, and run it past the edge both ways, which leaves a little ball on each corner, which might make for a cool little detail. Of course it will drive your grandkids crazy trying to get the little balls off, unless they manage to, then it will make you crazy. ha

Re: Installing cockbead question

#4

Re: Installing cockbead question

Keith Newton----Little Rock, Arkansas

I didn't read your question carefully enough. If you are wanting to just cut the rabbit for the bead. I would just use a router using an edge guide.

Re: Installing cockbead question

#5

Sled with cradle to hold fronts.

Ray - Middletown, IN

Make a simple sled out of scrap ply and some 1 by stock. You can add stops or anything needed to hold front secure.

Ray