Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

How to Make Fluted Pilasters

Posts

How to Make Fluted Pilasters

#1

How to Make Fluted Pilasters

Bartstar

I would like to make some fluted pilasters to add some decorative elements to the vanites I'm making. I was planning to use a small cove bit on my router table and adjust the fence to create 3 flutes.

Question - how do you create the tapered ends to the flutes?

Thanks

Bart

Re: How to Make Fluted Pilasters

#2

Lee Grindinger

Gouge

Lee Grindinger

I did an awful lot of these. I'd use either a router with a core box bit, or a moulding head in a table saw to cut the flute, then a gouge to finish the ends, if I remember correctly a #6, 1/2" gouge worked perfectly for a 1/2" flute. I can post a pic or two of the finished product if you like.

Lee

Re: How to Make Fluted Pilasters

#3

If you go berserk,

Bill Houghton, Sebastopol, CA

and use a capital and a plinth - head and foot - to reference classical columns, you can also run the flutes straight through.

Re: How to Make Fluted Pilasters

#4

William A. Roland

Re: How to Make Fluted Pilasters *LINK*

William A. Roland

You need two 2X4's od 2X6's with 30 or 45 degree angle cut on them. They should be long enough to clamp on your stock and allow router to ride up on them at the ends tapering the ends of the flute. You may have to practice on sample stock to profect the procedure. Link is to some I did this way.


Fluted cabinet