Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

OT-solvent for copper anti-seize

Posts

OT-solvent for copper anti-seize

#1

OT-solvent for copper anti-seize

Tom Dunlap

Yesterday I put front brakes on my van. All of the screws cam out easily...whew!

When I reassembled I used Locktite where I should and then wanted to put thread lube on the others. My tub of thread lube isn't as liquid as it used to be. Does anyone know what solvent might be used to thin out the paste? I've tried looking for an MSDS for the lube but haven't found one that lists all of the ingredients.

When I took the wheels off the rear I found that the drum is seized onto the hub. This morning I'm going out and warming up the drum with my torch. When it goes back together there will be a generous layer of anti-seize on the hubs!

Re: OT-solvent for copper anti-seize

#2

Re: OT-solvent for copper anti-seize

Jim Smith

Hello, Having worked in a paper mill for forty plus years as a pipe fitter doing lots of work with steam fittings and gaskets never seize is your best friend, we always used whatever light oil was handy but mostly spray cutting oil was the widely used oil for looseing up stiff never sieze, and we never had any problem with any never sieze used this way. Will add that it will only take a small amount of oil to bring it back to life. Jim

Re: OT-solvent for copper anti-seize

#3

Re: OT-solvent for copper anti-seize

charles in mtl.

Tim,

See attached technical document from loctite. it says napthenic oil so that makes me wonder if the volatile component is a naptha type substance.

Re: OT-solvent for copper anti-seize

#4

Re: OT-solvent for copper anti-seize

Justin Szeliga

I seem to remember my auto shop teacher saying that there could be a problem combining antiseize compounds with brake parts. I think that the combination of heat from the braking action & the centrifugal force of the wheel spinning could get the lubricant in place you don't want it, ie; on the brake drum or pads.

Re: OT-solvent for copper anti-seize

#5

anti-seize-brakes

Tom Dunlap

If the anti-seize does get slung around at least I won't have to worry about squeaky brakes!

There's a chance that some might get on the pads/discs. When I use anti-seize its just enough to coat the parts. The drums on both sides were rusted onto the hubs. I had to use my torch to warm the inner hub rings to get them to come off. That's where the anti-seize got a generous coat.

Re: OT-solvent for copper anti-seize

#6

Re: OT-solvent for copper anti-seize

Alexandre Grigoriev

"drum is seized onto the hub."

Did you forget to disengage the parking brake?

Re: OT-solvent for copper anti-seize

#7

Re: OT-solvent for copper anti-seize

Tom Dunlap

Oh, no...the parking brake was off and the shoes were retracted. I cut my teeth changing the brakes on my '64 Dodge back in '74 :)

The fit of the hub and drum is snug. It only took a little rust to fuse them together. It only took a little oxy-acetylene to warm up the drum and release it.