Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Name this delta Drill press

Posts

Name this delta Drill press

#1

Name this delta Drill press

David Miller from Iowa

I collect, buy and sell vintage Delta, have all the old catalogs and in general thought I knew all about them. Until I saw this picture on Craigslist. I'm going to try and buy it tomorrow, but I have never seen anything like it, nor can I find it on OWWM. Pretty standard bottom half with a nice production table - but can someone tell me about this head I have never seen before? What is that round dial on front?

Thanks, David


Re: Name this delta Drill press

#2

Speed indicator on the front

McKay

Re: Name this delta Drill press

#3

Looks Like

Mark Mandell - Gone Round In Jersey

a Reaves drive variable speed. The 1-spoke-missing hand wheel on the left of the face would be the speed changer and the large dial would be the speed indicator.

Re: Name this delta Drill press

#4

Betty Lou? ;-)

Thomas Skaggs, Foothills of Mount Level

Re: Name this delta Drill press

#5

Is Comin' Out Tonight!!

Mark Mandell - Gone Round In Jersey

Re: Name this delta Drill press

#6

With a face like that?  I'd vote for "Conan"

Bill Houghton, Sebastopol, CA

Re: Name this delta Drill press

#7

Re: No help but dumb question

Stuart Johnson

Just to prove the point about no dumb questions:

What are the slots in drill press bases used for?

Re: Name this delta Drill press

#8

Wildly speculative answer

Bill Houghton, Sebastopol, CA

I've always assumed that they were for holding jigs and fixtures for really tall objects where the table travel isn't enough to get it under the head.

Re: Name this delta Drill press

#9

Re: Not Dumb

Mark Mandell - Gone Round In Jersey

he slots are there as fixing points for clamps and such to secure a workpiece in an effort to prevent it from spinning. There are those who insist on hold workpieces by "hand". You can usually ID them by the scars on their left hands

Re: Name this delta Drill press

#10

Re: No help but dumb question

FredD

Most Drill Presses are designed for Machinists and the slots accommodate vises, to clamp material , I have a couple of them.

FredD

Re: Name this delta Drill press

#11

Re: No help but dumb question

AZ in Colorado Springs

I use 'em to try and blow out the crap that has collected below. We used to be able to tip the DP back a bit and clean under it, but the safety office decided it had to be bolted to the floor.