Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Painting, clever or complete lunacy?

Posts

Painting, clever or complete lunacy?

#1

Painting, clever or complete lunacy?

Barry Irby

Working on the house I bought at foreclosure. In one room the previous occupants pulled down wallpaper on two walls leaving a texture like canvas and then painted all four walls Pepto Bismol pink. (the current rage color for little girls) So, two walls had wall paper directly on the dry wall, no sizing, and two had painted wallpaper glue.

We took the paper down about a square inch at the time and scrubbed off the glue as best we could. We made numerous repairs on the other two walls and tried to sand or scrub off the texture of the glue, but had little success. At that point I thinned some drywall compound to about the consistency of sour cream and roll a thin coat over the pink. Now I am waiting for it to dry. The plan is to sand it as smooth as possible. It has a very slight "roller" texture.

So, what do you think? Good or bad?

Re: Painting, clever or complete lunacy?

#2

Re: Painting, clever or complete lunacy?

Chrispy400623

You can buy 1/4' sheetrock designed to cover such a mess as yours, at HD or Lowe's

Chris

Re: Painting, clever or complete lunacy?

#3

Re: Painting, clever or complete lunacy?

Galen Vetterick

If you wanted painted walls it may have been easier to put on paintable wallpaper. Seen this done and did not look bad and there are textures and patterns, but harder to match strips.

Could the wallpaper glue texture actually be the paper back to foil or vinyl faced wallpaper? I have seen people think they are removing the wallpaper and actually just peal off the face layer.

Not sure how well your skin coat will adhere to the paint as not much tooth.

Once you sand and leave only filled areas and then apply a primer paint it may just wash off the skin coat. If it was the paper back the primer will just make the paper fuzz up again.

I'm too old to do that kind of fix and repair thank God!

Good luck!

Re: Painting, clever or complete lunacy?

#4

Jason Roehl in Lafayette, IN

You were halfway there.

Jason Roehl in Lafayette, IN

Rolling on the joint compound was a good idea, but troweling it would have been better than just sanding it. You could have done two coats pretty quickly (you'll always miss little things or not quite get the texture filled), primed, painted, then had a Level 5 wall. Adhesion to old wallpaper glue that's been painted shouldn't be an issue.

Jason

Re: Painting, clever or complete lunacy?

#5

Re: You were halfway there.

Barry Irby

I played with troweling it, but did not know what I was doing. It appeared I was taking all the mud off the wall. I think this is going to work. I am tempted to paint it the way it is, but I may sand it . This whole house has been a bear and this is the last room. I'll be glad when its over.

Wonder if there is a video on how to do this? I am basically making it up as I go along. Would also like to learn how to do the "knock down" finish.

Re: Painting, clever or complete lunacy?

#6

Jason Roehl in Lafayette, IN

Re: You were halfway there.

Jason Roehl in Lafayette, IN

Knock-downs are usually accomplished by texturing, then lightly skimming (while still wet) with a squeegee, but I haven't had the opportunity to mess with it at any significant scale.

Jason

Re: Painting, clever or complete lunacy?

#7

Could you explain "Level 5"

Barry Irby

I went to You Tube and was stumbling around inthe drywall videos and someone else mentioned doing level five work. Where can I learn more about Level Five and who sets the standard?

Re: Painting, clever or complete lunacy?

#8

Jason Roehl in Lafayette, IN

Re: Could you explain "Level 5"

Jason Roehl in Lafayette, IN

It's a union/architecture term. Because I'm not union, I'm a little fuzzy on the particulars, but I do know that it means walls are fully skim-coated so that there is no texture difference between mudded-over fasteners/seams and the paper facing of the drywall. Pretty much it means to get it as close to perfectly smooth as possible, and will allow the shinier paints to look good, as opposed to highlighting every defect.

Jason

Re: Painting, clever or complete lunacy?

#10

Thanks, Did not think of Wikipedia.

Barry Irby

I'll have to spend some time reading that site. I appreciate your information and effort. Thanks again.

Re: Painting, clever or complete lunacy?

#11

Hey Jason, more questions...& a report

Barry Irby

When you paint interiors, do you spray or roll? If you roll, do you use a nine inch or eighteen inch? Is there any real advantage to the 18" roller?

As I mentioned, we rolled thinned sheetrock mud on the walls. You could still see the pink paint through it. Today we sanded it and primed the walls. Wow, what a difference! Much better than not coating the walls. Much more even texture. The only problem was the sanding. I power sanded with a five inch ROS, pole sanded some and hand sanded some. Spent about two hours on it. What a mess. Cloud of dust does not do it justice. Would it have been as good to roll on perhaps thicker mud and cut it off with a knife or trowel?

Re: Painting, clever or complete lunacy?

#12

Jason Roehl in Lafayette, IN

Re: Hey Jason, more questions...& a report

Jason Roehl in Lafayette, IN

Generally, if the floors are finished, we don't spray, but that's not a hard-and-fast rule, it just depends on the job. It's more of an application of experience to the trade-off of the time involved in protecting what can't get paint on it and the extra time spent brushing and rolling. For the most part, we only spray large areas when they're new drywall or need a special primer of some sort, or if they're textured ceilings (if they're popcorn textured, we ONLY spray them, whatever it takes). If we have a lot of trim to paint, we try to spray that if we can, too, since that is very slow to do by hand.

As for sanding drywall, get a drywall bag for your shop vac and duct tape the vac hose to your ROS if you have to. It makes a HUGE difference. A Radius 360 sander is a good way to go, too (it's a round-headed pole sander--it doesn't flip and gouge the wall like the rectangular ones do).

Jason

Re: Painting, clever or complete lunacy?

#13

Is sanding required?

Bill Houghton, Sebastopol, CA

This is partly a question to Jason.

We've taken, on our remodels of This Auld Haus (1895 Queen Anne) to aiming for a final mud coat that we don't sand. This leaves some irregularities, but they're consistent with the irregularities in the lath-and-plaster walls, and add some interesting texture of their own.

Is there a reason to sand the mud other than knocking down nibs and bumps, if that's the effect you want? Does it help with paint adhesion?

Re: Painting, clever or complete lunacy?

#14

Jason Roehl in Lafayette, IN

AFAIK, no...

Jason Roehl in Lafayette, IN

...sanding is not an absolute necessity. Joint compound is a homogeneous material, so sanding will only change the physical appearance of the surface. It's also very porous, so virtually any coating you apply will have good mechanical bonding to the surface, with one caveat. If it is a quick-drying, thick material, it may not penetrate enough to sufficiently strengthen the joint compound's particulate structure. Glossier acrylic/latex paints tend to fall in this category, so any paint not specifically rated as self-priming on drywall should be preceded by a primer. Ideally, you would also let joint compound cure for about two weeks before painting, but I don't think I've ever seen that deliberately happen on new construction.

Jason

Re: Painting, clever or complete lunacy?

#15

Re: Painting, clever or complete lunacy?

Joseph Mulherin, Sr

Barry, since you do remodeling on houses, try this technique for covering old surfaces: apply drywall compound with a knotched trowel...1/8" is good..., let dry thoroughly, then skim over that with another coating of drywall with a smooth trowel. This should give you a consistent smooth look with little if any sanding needed.

Re: Painting, clever or complete lunacy?

#16

Very good Idea!

Barry Irby

I have been trying to figure out how to "screed" the mud. In concrete we set up pipes or forms to run the trowels or screeds on. The surface of the form or pipe determined the surface of the concrete. I was trying to figure out how to set up something that would create a very thin layer of drywall mud. You may have given me the answer. Thanks.

Re: Painting, clever or complete lunacy?

#17

Wandering off topic

Bill Houghton, Sebastopol, CA

"Ideally, you would also let joint compound cure for about two weeks before painting, but I don't think I've ever seen that deliberately happen on new construction."

Given that I've seen framing beginning on places practically as the foundation forms were being pulled (for a material - concrete - that doesn't develop full strength for 30 days), no, I don't imagine people wait for the compound to cure.