Confused...
John in NM
Are you comparing prices on dowels to bdft pricing? Obviously I haven't looked at McFeely's lately.
About 5 years ago, teak was right around $15/bdft, IIRC. Then it went up fast to about twice that, at least around here. One can only hope its dropped back down to reasonable levels.
By all accounts, teak is exceedingly weather proof. Trouble is, joints aren't. Seen lots of factory made "outdoor" furniture that is falling apart after 10 years or so because it's put together with dowels and pva.
Bob Hackett just mentioned using it for hammer handles over on the hand tools board. I made one once and broke it within a week (claw hammer, teak would probably work better for little tappy hammers, but then anything stronger than basswood would too). Its also the only wood I've worked with that actually lives up to its reputation for dulling steel blades quickly.
On the plus side, the stuff makes the best cutting board you've ever seen
I also really like the feel of it for tool handles, its very grippy. I have enough scrap left from my one teak project to make a couple gunstocks, they're going to look very utilitarian, but I bet the feel will be perfect. After that, I doubt I'll ever buy more of it.