Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Coping sled suggestions?

Posts

Coping sled suggestions?

#1

Coping sled suggestions?

paul in AZ

I am finally getting around to playing with the shaper I recently bought. What i would like is some guidance on a coping sled. This is for the small Jet shaper. I have seen all sorts of shop made jigs but do not want to go that route nor do I want to get something flimsy. Overkill is OK within limits but I'm looking at a huge pile of AMex points that I can use on Amazon so there is that temptation.

Two that have caught my eye are the Woodhaven and the Infinity. Anyone out there with experience to tell me why I'd choose one over the other, or other options to consider?

Thanks.

Re: Coping sled suggestions?

#2

Re: Coping sled suggestions? *LINK*

Dave Paine

Another model to consider is from Woodpecker's. I have this one, solidly built. I have not yet needed to use it, but wanted to have a good coping sled on hand for when I do.


http://www.woodpeck.com/copingsled.html

Re: Coping sled suggestions?

#3

Re: Coping sled suggestions?

Gerald Gibbs

if I want to make my own sled for my router, why do I need a track slotted in the router table, or in my case the table saw wing? why can't i just use the edge of the table or wing as a guide?

Re: Coping sled suggestions?

#4

Re: Coping sled suggestions?

Dave Paine

As you state, you can use any edge. The Woodpecker's uses a top piece which slides across the router fence. I think the Infinity does also.

If you are routing the ends of a piece rather than the side, the main consideration is that the sled holds the piece at right angle to your fence. Many ways to achieve this.

I have a mitre slot in my router table, since it came this way. If I were to build a router top myself, I may not include a mitre slot, since I have rarely used this.

The table saw is different. I use the mitre track a lot.

Re: Coping sled suggestions?

#5

Re: Coping sled suggestions?

paul in AZ

I may be a little confused but it seems that once you have your depth of cut set and the wood firmly clamped in the jig perpendicular to the miter slot there is no need at all for a fence as a guide. Or am I wrong here?

Re: Coping sled suggestions?

#6

Re: Coping sled suggestions?

Dave Paine

This depends on whether the sled is using the mtire slot.

If the sled does not use the mitre slot, then you will need to use the fence.

If the sled uses a mitre slot, you do not need a fence.

You need to decide the method to control the depth from the router bit.