Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Bandsaw blade vibrrration

Posts

Bandsaw blade vibrrration

#1

Bandsaw blade vibrrration

Yonak

I'm getting this bothersome blade chatter which causes me to not be able to follow the cutting line so well, as well as extra sanding. I notice it when I'm cutting 1-3/4" ash wood, but not thinner or softer woods. It seems to be much more noticeable when the wood grain is more perpendicular to the blade and less so when the grain is going along with the blade.

I use 1/4" Lenox bi-metal 6 tpi hook blades. I'm cutting 1" radiuses so the curve isn't too tight. It tends to abate some for periods of time and I think something has changed to fix it, then it will come back. It doesn't seem to matter whether I've just started the cutting operation or if I'd been at it for awhile, so I don't think the heat of the blade is involved. I've tried running the wood through faster and slower, trying to hold the wood more firmly to the table (although it's the blade vibrating, not the wood) and holding my mouth differently, but I can't figure out a solution.

Has anyone else experienced this and found a way to solve it ?

Re: Bandsaw blade vibrrration

#2

Re: Bandsaw blade vibrrration

paul in AZ

Several thoughts:

A 1/4" 6tpi blade seems on the thin side for 6/4 hardwood.

Is the blade sharp?

Does putting more tension on it help?

The ash I've cut on my saw is specially tough and hard so a wider, really sharp blade may be called for.

Re: Bandsaw blade vibrrration

#3

Re: Bandsaw blade vibrrration

Yonak

Thanks, Paul. Yes, I've tried more tension and a new blade. However, using a wider blade seems like a logical try. I'll do it.

Re: Bandsaw blade vibrrration

#4

Re: Bandsaw blade vibrrration

FredD

For a circle that tight, a wider blade will make your problem worse , not better.

Check to see how close your side guide blocks are to the blade, , if they are set wide , run them right up to touching the blade and see if that reduces or elimnates the chatter.

FredD

Re: Bandsaw blade vibrrration

#5

Try honing the back of the blade.

David R Smith, Longview, WA