Carving stand
Don Peek
Looking for ideas for a shopmade carviing station. I want to use my chuck and a bolt two to match my spidle sizes. I'm not interested in a bajo or lathe mounted stand. Anyone have any pictures, ideas. or plans.
Don
Knowledge You Can Build On — Est. 1998
Carving stand
Don Peek
Looking for ideas for a shopmade carviing station. I want to use my chuck and a bolt two to match my spidle sizes. I'm not interested in a bajo or lathe mounted stand. Anyone have any pictures, ideas. or plans.
Don
Don, I have had thoughts, BUT,
Keith Newton----Little Rock, Arkansas
have not gotten around to making one.
When I am carving my turnings, I am usually sitting straddle a carpenters bench which has a carpeted top. I capture the work between my knees, which is pretty good from a lot of respects, like friendly to the work, and quick to change positions, and in a fairly handy location. Except for being a little low, which makes my shoulders get tired pretty quickly.
I have pondered the idea of building a bench which would be a lot like a shaving horse, in that I would sit straddle of it, and the work would be held about chest high. I was thinking about having an assortment of three jaw sizes which would interchange for different size projects, that would be activated by my sitting on the seat, which would be on an arm, hinged on the other side of the jaws.
The top of the jaws would have a canvas or leather top or seat that would cradle the work. There might be a ring or something that drew the jaws inward when I sat down on the seat.
Of course there would be a nice tool caddy on both sides, and good lighting overhead and on each side which could be adjusted just right.
If like this idea, and get inspired, could you just make two while you are doing it, and send me the other one? thanks,,,,,%\],,,,,,,,k
Re: Carving stand
Gary Smyth

This may not be what you have in mind, but if you check "Carving Vise" on most any browser you can find commercial and homemade units. Fine Woodworking also once featured a male screw for the mounting end and a ball in a vise for the bottom. I can't find that photo/illustration but there will be plenty from which to get ideas. 
You can look under sculpture vise too.