Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Problem making a clean "Tall" cut

Posts

Problem making a clean "Tall" cut

#1

Problem making a clean "Tall" cut

Paul Woolson

Hi all,

I have a common need to make a "tall" cut. Let me explain:

I have a 1/2 x 3-1/2 x 5" long piece of stock that I need to make a bevel in. So I made a 8degree sled for it to ride through my band saw. My table saw blade obviously won't go that high.

Well, I'm not happy with the finish of the bandsaw blade. So I have to then cut it shallow and take it to a jointer. Adding another step to a frequently cut item ads a lot of time in the long run.

Anyone have any thoughts as to how I can get a clean cut that is 3-1/2" tall?

Thanks, Paul

Re: Problem making a clean "Tall" cut

#2

plane it

Bill Tindall, E TN

Make an 8 degree taper "sled" and run a long piece through a thickness planer, then cut to length.

Re: Problem making a clean "Tall" cut

#3

JL

Re: Problem making a clean "Tall" cut

JL

Not meaning to sound "flip" or anything - but how about changing your band saw blade? I've really been surprised what can happen when you change a blade and tweak the alignments. Fine tuning your band saw may also help.

Another thought - I've made 3-5 degrees sleds for my planer. I use double stick carpet tape on the sled and just plane away. It should work reasonably well for your application also.

Re: Problem making a clean "Tall" cut

#4

Clint Searl

Re: Problem making a clean "Tall" cut

Clint Searl

Crank the TS blade over to 8 Degrees and run it through long ways; or am I not visualizing it properly?

Clint

Re: Problem making a clean "Tall" cut

#5

Re: Problem making a clean "Tall" cut

Paul Woolson

Thanks Guys! I knew I could count on you. I think running it through my wide belt on a jigged sled is the answer.

Much appreciated.

Re: Problem making a clean "Tall" cut

#6

Re: Problem making a clean "Tall" cut

Paul Woolson

I probably wasn't clear but doing this would require even more blade as it is 5" tall.

Re: Problem making a clean "Tall" cut

#7

Moses Yoder

Re: CNC

Moses Yoder

If you are making these parts by the hundreds I would suggest taking it to a cnc shop. They could make a tapered jig to clamp it on the table and then take off the top. A cnc leaves a nice flat surface if the blades are set right that would require very little sanding.

Re: Problem making a clean "Tall" cut

#8

Ellis Walentine

Bandsaw and planer

Ellis Walentine

... or planer alone. Just make a tapered jig like someone suggested and run the rectangular board through as many times as needed, then cut to length. You'll need a hook on the back of the jig to hold it stationary while your planer feeds the board through.