Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Making Mortises with a Fein Multimaster

Posts

Making Mortises with a Fein Multimaster

#1

Making Mortises with a Fein Multimaster

Stephen

I am starting a sculptural project where I am taking a piece of a tree trunk and inserting a bunch of little drawers. The drawers will be randomly placed on the trunk, and about 2 x 2 inches in opening dimension. The depth does not matter too much, but will probably be about 4 inches. There are small branches on the trunk, so setting up a router template is not really doable.

I was wondering if anyone had experience using a Fein Multimaster to do plunge cuts for making mortises like this. (The wood is big leaf maple. Hard, but not so bad.) I know I would probably have to clean up the mortises with a chisel, but I wanted to at least hog out a big square hole, or at least the sides of a big square hole), and was hoping the blade ran true for at least the first 2 or so inches.

Yes, I could drill a 2" round hole and then chisel out the corners, but then I would not need to buy a new tool!

Re: Making Mortises with a Fein Multimaster

#2

Re: Making Mortises with a Fein Multimaster

Bill Tindall

I can't answer your question but I hope you post the result when it is finished, or even some steps along the way.

Using the tools I have at hand, I would drill out the waste as best I could and then chisel. What you need to accomplish is no different than making a mortise in post and beam construction.

Re: Making Mortises with a Fein Multimaster

#3

I think you'd be disappointed

Neal in San Jose

I have a Multimaster and about twice a year it solves a problem that I would be hard-pressed to get around without it. However, it is not very fast, especially in a completely boxed cut like you are describing. There's no place for the sawdust to go, the teeth get packed up, stop cutting and then it starts burning. Those blades get REALLY hot. If you can make relief holes, like drill a series of small holes along the line you want to cut, it would probably work, altho slowly. The blades would probably still get REALLY hot.

This wouldn't be my first choice of doing something like that. Drilling big holes and a chisel would probably be a faster method. And, chisels don't get REALLY hot.

Did I mention those blades get REALLY hot? DAMHIKT

Re: Making Mortises with a Fein Multimaster

#4

Re: Making Mortises with a Fein Multimaster

AZ in Colorado Springs

I'd suggest using a 3/8" brad point bit to dril a series of holes along each side of the rectangular mortise (just to the inside of the cutline). Use a 1/4" bit in and near the corners. You then use a wider bit to hog the waste out of the center (a spade bt might work ok, depending on how flat you want the bottom to be). With this "dotted outline" just to the inside of the cut lines, clear out the waste, then use a wide chisel to straighten and clean the sides of the mortise.