Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Bench and Leg Vise Question

Posts

Bench and Leg Vise Question

#1

Bench and Leg Vise Question

Steve Kirincich

I am the owner of a trestle style workbench - this means that the legs are not flush with the edge of the top. I have been considering installing a leg vise, but these seem to usually appear on benches where the legs are flush with the top. Since the area of the chop above the screw is the most used area for clamping pressure, can you see a problem with a vise installation where the leg is made flush (with the top edge) only in the area above the screw? Thanks.

Steve

Re: Bench and Leg Vise Question

#2

Re: Bench and Leg Vise Question

wilbur

You'd also have to make the area around the screw and where the parallel guide slot is coplanar with the clamping area. By that time, you might as well have a leg that is fully flush with the top.

I hope I'm not being too discouraging. The leg vise that I have is really great. I love using a leg vise. And since you already have a workbench, if you are really motivated, you could make a base that will sit flush with the top with your current workbench and replace the trestle base that you have. Regardless whether you wind up with a leg vise or some other sort of face vise, having the legs flush with your benchtop is a really nice feature to have.

You might want to repost this in the Hand Tools board. Us hand tool types always are talking about workbenches. ;)

Re: Bench and Leg Vise Question

#3

Re: Bench and Leg Vise Question

Bill Houghton, Sebastopol, CA

If you decide to install this, bring the rear jaw of the vise up through the benchtop. My grandfather, who generally had great design sense, installed his leg vise so that the benchtop ran across the top of the rear jaw (which was a widened front leg), and clamping things in the vise would move the top backwards.

Re: Bench and Leg Vise Question

#4

Re: Bench and Leg Vise Question

Marv

Bill,

I can't quite picture that in my mind.....could you draw us a picture?

Marv