Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Twin M&T Joint

Posts

Twin M&T Joint

#1

Twin M&T Joint

Mark Mandell - Gone Round In Jersey

Doing a substantial table frame and two of the lower-leg stretchers are 1-3/4" thick so I'm planning on cutting twin 1/2" tenons and mortises for the joints to maximize glue surface (yes they will be "pegged" as well). The question is the old one of do you cut the mortise(s) or tenon(s) first.

I cut tenons on the router table, and have/use a JBM-5.

ps: Dominos a/o loose tenons are not an option.

tia

Re: Twin M&T Joint

#2

Re: Twin M&T Joint

wilbur

I always make mortises first, whether it's a single or double mortise and tenon joint.

I'd rather do it by hand than a router, but that's another discussion entirely. ;)

But the principle remains the same.

Re: Twin M&T Joint

#3

Re: Twin M&T Joint

Sgian Dubh

The normal order of work is to excavaye the mortice first and cut the tenons to fit. The reason being that most equipment, even a hand bashed mortice chisel, is best suited to making a mortice that is the width of the cutting tool, eg, 1/4", 5/16", 3/8", 6mm, 9mm, 12mm, etc. You can, generally, easily adjust the tenon thickness to suit any mortice. Slainte.

Re: Twin M&T Joint

#4

mortises first

Bruce, a MN Galoot

I just did two sets of twin tenons for a cabinet. Mortises get cut with a router using the same set-up for both, all mortises cut at the same time. The mortises are squared off with a chisel.

Then the tenons get cut on a tablesaw tenon jig to match the mortises.

The most important thing is to not make any money cuts without trying them on scrap first. The tenon cheeks are the critical cuts. If you go slow and get them fitting right with scrap, the real pieces are significantly easier and should be a snap .

Re: Twin M&T Joint

#5

Thanks

Mark Mandell - Gone Round In Jersey

That's what I figured, but it's always best to ask first.