Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Sheeting for trailer sides

Posts

Sheeting for trailer sides

#1

Sheeting for trailer sides

Tom Dunlap

My single axle trailer needs to be resided. The sides are about 50" tall and 9' long.

What is a good choice for sheet goods to enclose the trailer? The angle iron frame is on about 2' centers. No matter what material I use it will be primed and painted before it's bolted on.

Maybe metal sheeting, some sort of composite, plywood, chip board???

Re: Sheeting for trailer sides

#2

JL

Re: Sheeting for trailer sides

JL

Chipboard (OSB) has a horrible surface. I usually manage to tear it up. I can never get it to seal properly. MDF or particle board isn't intended for wearing surfaces.

That leaves plywood, metal or some other. My personal preference is for plywood. I can cut that easier than I can cut metal. It's also reasonably priced.

If you could make it a "slat" trailer - I would suggest one of the composite decking materials such as Trex. The decking seems to last forever.

Re: Sheeting for trailer sides

#3

Re: Sheeting for trailer sides

Barry Irby

You could look at MDO, medium density overlay. Often used for signs and holds up well outdoors. Has a smooth somewhat tough surface, but the size is awkward and the MDO comes in 48 x 96 sheets or perhaps 49 by 97. I don't know what the cost is.

I would also look at 5/4 by 6 "deck" boards. As treated wood, they would last a long time and you can replace any individual pieces that get damaged. Be careful with the Trex type material, is really pretty flexible and very heavy.

Re: Sheeting for trailer sides

#4

Re: Sheeting for trailer sides

Dave Nichols

I'd use pre-finished aluminum sheets