Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Workbench Vise Retrofit

Posts

Workbench Vise Retrofit

#1

Workbench Vise Retrofit

Steve Kirincich

As a matter of full disclosure, I am probably suffering from tool and bench overload after attending Woodworking in America.

I have a decent workbench I built several years ago from a Shop Notes plan, but the vises really stink, and are ready to be replaced. A leg vise seems quite appealing, but my current workbench does not have legs that are flush with the edge of the benchtop. I suspect that building up the thickness would not be too involved. Does anyone have experience with such a project? I should provide a photo in a follow-up post. Thanks.

Steve

Re: Workbench Vise Retrofit

#2

Re: Workbench Vise Retrofit

FredD

Check out the tail vise at Leevalley.com , you only need a 17" wide by 6" deep on the bench end to accomodate it.

Veritas Tail vise,, Leevalley.com

FredD